Weider user manual Remove this Part Identification Chart from the Manual, WESY74091 R0101A

Page 21

REMOVE THIS PART IDENTIFICATION

CHART FROM THE MANUAL

This chart is provided to help you identify the small parts used in assembly. The number in parenthesis below

each part refers to the key number of the part.Important: Some parts may have been pre-assembled for shipping purposes. If you cannot find a part in the parts bags, check to see if it has been pre-assembled.

Note: Assembly is divided into three stages: 1) frame assembly; 2) arm assembly; 3) cable, pulley, and seat assembly. The hardware for each assembly stage is packaged separately. Wait until you begin each stage to open that parts bag.

WESY74091 R0101A

Image 21

Contents Serial Number Decal Model No. WESY74091 Serial NoLimited Warranty Table of ContentsImportant Precautions Make sure the cables remain on the pulleysKeep hands and feet away from moving parts Before You Begin Using the weight systemAssembly To make the assembly process as smooth as possiTo complete the process over a couple of evenings See the inset drawing Locate and open the parts bag labeled Frame AssemblyBolts with two 5/16 Nylon Locknuts Tighten the Nylon Locknuts yetDo not tighten Nylon Locknuts3 yet Place the Top Frame 55 on top of the UprightSlot FrameTop Frame Top Frame Weight Guide TubeLocate and open the parts bag labeled ARM Make sure the welded tab on the Press FrameTion of the welded bracket a on each Arm Short Cable 58 is between the Pulley 15 Locate the parts bag labeled Cable AssemblyBolt 12 and a 3/8 Nylon Locknut Cable Trap is oriented as shownSpacer 8 x 1 Bolt 59, a 3/8 Plain Nut 56 and a 3/815b Ing the following steps. Note Make sure the Pulley Onto the Bolt to prevent the Pulley from falling off durView from behind From Pulley To Pulley BracketBolt 12 and a 3/8 Nylon Locknut 21. Note Make sure the Cable Trap is oriented as shownSpacer To the Seat 13 with two 1/4 x 3/4 Screws Shooting and Maintenance on Cable DiagramsLong Cable 76, 87 1/258, 126 1/4 Cise will be reduced Changing the Weight Setting AdjustmentAdjusting the Arms for Butterfly or Press Exercises Attaching the Lat Bar to the Pulley StationCable and re-install it Trouble-shooting and MaintenanceWeight Resistance Chart Station LeverTop Part No R0101A Ordering Replacement PartsWESY74091 R0101A Remove this Part Identification Chart from the ManualPart Identification Chart-WESY74091 Page Page Remove this Part LIST/EXPLODED Drawing from the Manual Part List-Model No. WESY74091 Qty Description16 x 2 1/4 Bolt Backrest Nylon Locknut Exploded Drawing-Model No. WESY74091 R0101A