Weider WESY5984.1 user manual Locate the Long Cable 80. Insert one end

16. Locate the Fulcrum (18) on the Lat Tower (4) (see	16		86
the inset drawing). Slide the Tray (35) onto the
				Edges
rods on the Fulcrum. Make sure the Tray is ori-		72
ented as shown in the drawing.				up
Set the resistance bars into the Tray (35) in the
following order: the 10-pound Removable					96
Resistance Bar (67), the 20-pound Removable
Resistance Bar (36), an 80-pound Resistance Bar	Rings on
(95), the 10-pound Center Resistance Bar (44), an	this side				44
80-pound Resistance Bar (95), and the 40-pound
Resistance Bar (96). Make sure the indicated	4	35			95
rings are on the side shown and the arrows					95
point toward the Tray.		18		67	36
	18
Attach the Cover Plate (72), with the edges up, to			Rods
the Tray (35) with two M8 x 19mm Button Screws	17
(86).
17. Locate the Long Cable (80). Insert one end of				80	71
the Cable through the welded tube on the indicat-				11
ed end of the Cross Tube (11) and then through a
					104
Swivel Arm (22). If necessary, use the tip of a
screwdriver to pull the end of the Cable out of the			28		22
Swivel Arm. Be sure the Cable is on the indicat-
ed side of the welded rod in the Swivel Arm.
					Rod
Insert the Swivel Arm (22) into the welded tube					76
on the Cross Tube (11). Secure the Swivel Arm
with an M4 x 5mm Screw (104).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Swivel Arm	18
(22) with an M10 x 42mm Button Bolt (71) and an					76
				75
M10 Nylon Locknut (76).
			29
18. Wrap the Long Cable (80) around a 90mm Pulley		110
		73
(28). Attach the Pulley, a Cable Trap (29), an M10
				28	110
Washer (75), and two Finger Guards (110) to the
			80
indicated M10 x 147mm Carriage Bolt (73) with
an M10 Nylon Locknut (76). Make sure the
Cable Trap and Finger Guards are oriented as
shown.
	19
19. Attach a Pulley Housing (94) to the indicated “U”-
channel on the 10-pound Center Resistance Bar
(44) with an M10 x 128mm Button Bolt (24), two
Pivot Bushings (74), and an M10 Nylon Locknut
(76).		44
Wrap the Long Cable (80) over a 90mm Pulley		76
				“U”-Channel
(28). Attach the Pulley inside of the Pulley		74
Housing (94) with an M10 x 42mm Button Bolt		71		76
(71) and an M10 Nylon Locknut (76).				94
		28	74
		80		24
	10