10.Apply grease to an M10 x 77mm Bolt (79).
Attach the Pivot Frame (5) to the Top Frame (4) with the M10 x 77mm Bolt (79) and an M10 Locknut (56). Do not overtighten the Locknut; the Pivot Frame must pivot easily.
11.Attach the two Arm Pins (40) to the Pivot Frame
(5)with two M4 x 20mm
See the inset drawing, insert the Arm Pins (40) into the indicated holes in the Upright (3).
12.Apply grease to an M10 x 51mm Bolt (66).
Attach a Cable Pivot (39) to the Left Arm (10) with the M10 x 51mm Bolt (66) and an M10 Locknut (56). Do not overtighten the Locknut; the Cable Pivot must pivot easily.
Wet the inside of a Large Foam Pad (42) with soapy water. Slide the Large Foam Pad onto the Left Arm (10).
Attach a Handle (11) to the Left Arm (10) with two M10 x 25mm Button Screws (77) and two M10 Washers (57).
Assemble the Right Arm (9) in the same way.
10
Gtease
11
69
/43°¸
12
11
57
11