5. Attach the Seat | Tube (6) to the Upright (3) with | 5 |
two M8 x 65mm | Bolts (68), two M8 Washers |
|
(59), and two M8 Locknuts (58). Do not tighten the Locknuts yet.
Attach the Seat Tube (6) to the Front Leg (7) in the same way.
68
68
68
7 i! 68 ;_ 59 "
. Slide the two Weight Bumpers (27) onto the Weight Guides (21).
21
Orient nine Weights (22) so that the pin holes are on the bottom as shown. Slide the Weights onto the Weight Guides (21).
Insert the Weight Selector (24) into the nine
Weights (22). Make sure that the pin on the
Weight Selector is oriented as shown.
Apply some of the included grease inside the indicated holes in the remaining Weight (22). Then, slide the Weight onto the Weight Guides (21).
Grease
24
22
Pin