35. Attach a Shroud Support (19) and the bottom of | 35 | ||
the Left Shroud (17) to the Base (1) and the | |||
| |||
Stabilizer | (2) with four M4,2 x 16mm |
| |
ping Screws (49) and four M4 Washers (33). Do |
| ||
not tighten the Screws yet. |
| ||
Repeat steps 34 and 35 to attach the Right |
| ||
Shroud | (not shown). |
| |
See steps 34 and 35. Tighten the M4.2 x 16mm
33 1949
36. Attach the Curl Pad (14) to the Curl Post (13) | 36 | |
with two M6 x 16mm Screws (62). | ||
14 |
13
37.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 21.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly around the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If the cables are not properly used. See the CABLE DIAGRAM on page cables, you will need to remove the slack
installed, they may be damaged when heavy weight is 24 for proper cable routing. If there is any slack in the
by tightening the cables. See MAINTENANCE on page 25.
20