Electrolux 50550 Detergent and Conditioners Which detergent and conditioner?, Water Softener

Page 17

Instructions for use

Detergent and Conditioners

Which detergent and conditioner?

Use only detergents and conditioners which are suitable for use in au- tomatic washing machines. Always follow the manufacturer's instruc- tions.

 

How much detergent and conditioner?

 

The quantity required depends upon:

 

• the extent to which the washing is soiled

 

• the degree of hardness of the mains water

 

• the amount of washing

2

Should the detergent manufacturer not specify the dosage quantity for

 

less than full loads, reduce the detergent accordingly: for a half load

reduce the quantity by one third; for a small load or EASY IRON (FACILE A REPASSER/STRIJKVRIJ) reduce the quantity by one half. Observe the instructions for use and dosing provided by the detergent and conditioner manufacturer.

Water Softener

For medium to high water hardness (hardness category II or higher) you should use water softener. Pay attention to the manufacturer's instruc- tions. Always then meter detergent for hardness category I (= soft). The responsible water works can provide information on the local water hardness.

2

Since the water softener is added before the main washing detergent,

 

(water pre-softening), eighty percent of the softener quantity stated on

 

the package is sufficient.

 

 

 

Water Hardness Details

 

 

 

 

 

 

 

 

Water Hardness °dH

Water Hardness in mmol/l

 

Hardness Category

 

(degrees German

 

 

(millimol per litre)

 

 

 

hardness)

 

 

 

 

 

I – soft

 

0 - 7

up to 1.3

 

II – medium hard

 

7 - 14

1.3 - 2.5

 

III – hard

 

14 - 21

2.5 - 3.8

 

IV – very hard

 

over 21

over 3.8

 

 

 

 

 

17

Image 17
Contents Lavamat 50550 Electronic Dear customer Contents What to do if Setting up and connection instructionsPage Instructions for use SafetyBefore Putting into Operation for the First Time Correct UseGeneral Safety Child SafetyDispose the packing material DisposalFor polyoxymethylene, e.g. plastic clips Dispose the old applianceEnvironment Tips Drawer for Detergent and Conditioners Unit DescriptionFront View Main wash cycle for Cottons/Linen from 30 C to 95 C Control PanelProgramme Knob WOOL/SILK LAINE/SOIE, WOL/ZIJDE P Handwash Main wash programme for Delicates at 30 C or 40 CRinses, liquid additive washed in from compartment æ, spin Draining of the water after a Rinse Hold without spinningShorter washing cycle for slightly dirty washing Programme Option ButtonsPull out the washing powder drawer slightly Consumption values and programme timesBefore the First Wash Sort and Prepare the Washing Prepare the Washing CycleTypes of washing and care symbols Water Softener Detergent and Conditioners Which detergent and conditioner?How much detergent and conditioner? After the wash programme is complete Performing a Wash CycleBrief guide Add the Washing Opening and Closing the DoorLight indicate whether the door can be opened AgainDetergents and conditioners If using liquid detergents/tabletsAdding detergent/conditioners For the appropriate pro Setting the washing programmeAccording to the wash programme To change the Spin Speed for the final rinse orPLEINE, Spoelstop comes on Starting the Wash Programme Setting the delay timerWash Programme Progress Programme Progress DisplayChanging the washing programme Changing or cancelling the programmeWater is drained or the washing is spun Selecting a programme optionAfter a Rinse Hold, the water must first be drained End of Wash Cycle/Removing the WashingWashing Programme TablesSeparate Spinning Separate RinsingWashing Detergent Drawer Cleaning and CareFilling Door Washing DrumWhat to do if Remedying FaultsTransit bolt/bars were As described Not removed Screw the inlet hose START/PAUSE OFF ARRET/UIT If the washing is grey and limescale forms in the drum If the washing result is not satisfactoryIf there are still grey stains on the washing If foam is still visible after the final rinseCarry Out an Emergency Emptying Operation Housing foreign objects are protected by the pump wheel When all the washing solution has drained offBefore cleaning the drain pump Drain pumpInstructions for use Additional rinse cycles RINSE+/RINCAGE+, SPOELEN+ To cancel the additional rinse cyclesHelpful to rinse with extra water To set the additional rinse cyclesCancelling the Child Safety Feature Child Safety FeatureSetting the Child Safety Feature Safety Instructions for Installation Setting up and connection instructionsRemove the Transport Safeguard Setting Up the UnitTransporting the Unit TuresSupplied with the unit Special button a and the plug caps B 2 ea. and C 1 ea. areSetting Up on a Vibrating floor Prepare the Installation LocationSetting Up on a Concrete Pedestal Compensate for Floor Unevenness Permissible Water Pressure Electrical ConnectionWater Connection Water Inflow Draining the water into a basin Water DrainageWater Drainage into a Siphon Dimensions Technical DataDelivery Heads over 1m Measurements in mmBelgium Guarantee conditionsGuarantee conditions Tel Fax Customer servicesPage Additives IndexWhen do you incur costs even during the warranty period? ServiceAEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG