Electrolux 50550 manual Special button a and the plug caps B 2 ea. and C 1 ea. are

Page 43

	Setting up and connection instructions
3	The special button A and the plug caps B (2 ea.) and C (1 ea.) are
	supplied with the unit.

3. Remove the screw D, including the compression spring with the special button A.

4. Close off the hole with the plug cap C.

Attention! Push in the plug cap so firmly that it engages in the rear panel (this protects the inside of the unit against splash water).

5.Unscrew the two screws E using

the special button A.

6. Unscrew the four screws F using the special button A.

7. Remove the transport rail G.

8. Screw the four screws F back in.

9. Close off the two large holes with the plug caps B.

Attention! Push in the plug caps so firmly that they engage in the rear panel (this protects the inside of the unit against splash water).

Image 43

Contents Lavamat 50550 Electronic Dear customer Contents What to do if Setting up and connection instructionsPage Correct Use SafetyInstructions for use Before Putting into Operation for the First TimeGeneral Safety Child SafetyDispose the old appliance DisposalDispose the packing material For polyoxymethylene, e.g. plastic clipsEnvironment Tips Front View Unit DescriptionDrawer for Detergent and Conditioners Programme Knob Control PanelMain wash cycle for Cottons/Linen from 30 C to 95 C Draining of the water after a Rinse Hold without spinning Main wash programme for Delicates at 30 C or 40 CWOOL/SILK LAINE/SOIE, WOL/ZIJDE P Handwash Rinses, liquid additive washed in from compartment æ, spinShorter washing cycle for slightly dirty washing Programme Option ButtonsBefore the First Wash Consumption values and programme timesPull out the washing powder drawer slightly Sort and Prepare the Washing Prepare the Washing CycleTypes of washing and care symbols How much detergent and conditioner? Detergent and Conditioners Which detergent and conditioner?Water Softener Brief guide Performing a Wash CycleAfter the wash programme is complete Again Opening and Closing the DoorAdd the Washing Light indicate whether the door can be openedAdding detergent/conditioners If using liquid detergents/tabletsDetergents and conditioners For the appropriate pro Setting the washing programmePLEINE, Spoelstop comes on To change the Spin Speed for the final rinse orAccording to the wash programme Programme Progress Display Setting the delay timerStarting the Wash Programme Wash Programme ProgressSelecting a programme option Changing or cancelling the programmeChanging the washing programme Water is drained or the washing is spunAfter a Rinse Hold, the water must first be drained End of Wash Cycle/Removing the WashingWashing Programme TablesSeparate Spinning Separate RinsingWashing Detergent Drawer Cleaning and CareFilling Door Washing DrumWhat to do if Remedying FaultsTransit bolt/bars were As described Not removed Screw the inlet hose START/PAUSE OFF ARRET/UIT If foam is still visible after the final rinse If the washing result is not satisfactoryIf the washing is grey and limescale forms in the drum If there are still grey stains on the washingCarry Out an Emergency Emptying Operation Drain pump When all the washing solution has drained offHousing foreign objects are protected by the pump wheel Before cleaning the drain pumpInstructions for use To set the additional rinse cycles To cancel the additional rinse cyclesAdditional rinse cycles RINSE+/RINCAGE+, SPOELEN+ Helpful to rinse with extra waterSetting the Child Safety Feature Child Safety FeatureCancelling the Child Safety Feature Safety Instructions for Installation Setting up and connection instructionsTures Setting Up the UnitRemove the Transport Safeguard Transporting the UnitSupplied with the unit Special button a and the plug caps B 2 ea. and C 1 ea. areSetting Up on a Concrete Pedestal Prepare the Installation LocationSetting Up on a Vibrating floor Compensate for Floor Unevenness Water Connection Electrical ConnectionPermissible Water Pressure Water Inflow Water Drainage into a Siphon Water DrainageDraining the water into a basin Measurements in mm Technical DataDimensions Delivery Heads over 1mBelgium Guarantee conditionsGuarantee conditions Tel Fax Customer servicesPage Additives IndexWhen do you incur costs even during the warranty period? ServiceAEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG

The special button A and the plug caps B (2 ea.) and C (1 ea.) are

supplied with the unit.