Electrolux 1051 VI fele manual Positioning, Levelling

Page 46

Installation

Set the machine

upright and remove the two remaining bolts

from the back.

Pull out the three

plastic spacers from the holes into which the bolts were fitted.

Plug the open holes with the plugs which you will find at the back of the machine.

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc.

•Before placing it on small tiles, apply a rubber coating.

•Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.

•If it is impossible to avoid positioning the machine next to a gas cooker or coal-burning stove, an insulating panel (85x57 cm) covered with aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances;

•The machine must not be installed in rooms where the temperature can drop below 0.

•The water inlet hose and the drain hose must not be kinked.

•Please ensure that when the appliance is installed, it is easily accessi- ble for the engineer in the event of a breakdown.

Levelling

Carefully level by screwing the

adjustable feet in or out. Never place cardboard, wood or similar

materials under the machine to compensate for

any unevenness in the floor.

After having levelled the machine, tighten the lock nuts.

46

Image 46

Contents AUS Erfahrung GUT Dear customer Contents Programme charts Bulding-in General safety Safety instructionsInstallation Child safety During usePackaging materials DisposalMachine Tips for environmental protection Main features of your washing machine Description of the appliance Front viewControl panel Programme selector dialMains-on light Delay Start buttonON/OFF button START/PAUSE buttonProgramme Option buttons StainExtra Rinse DisplayCancelling a programme Programme progress displayAltering a programme which is running Opening the door after the programme has startedDetergent dispenser drawer Before the first washPreparing the wash cycle Sorting out and preparing the laundryCotton Weight of laundryTypes of fabric and care labels Cotton 40Delicates Detergents and additives Which detergent?Which form? Traditional PowdersLoad the laundry How to washSwitching the machine on Add detergent and additiveSelection of the spin speed Selection of the desired wash programmeSelection of the Extra Rinse and/or Rinse Hold option Selection of the Delay Start option Starting the programmeAt the end of the programme Programme chart Wash programmesSpecial programmes Additional Max Duration DryAfter each wash Cleaning and maintenancePeriodical cleaning Exterior Detergent dispenser drawerDrain filter Water inlet filterFrost precautions Emergency emptying outTroubleshooting Something not working?Problem Noisy Feet have not been Problem Possible cause Solution Foam is still visible even after the last rinse Unsatisfactory washing resultsIf grey stains remain on the laundry White residue is left on the laundryTechnical data This appliance complies with the following EC directives0990 929 Service & Spare PartsService & Spare Parts Help us to help youCustomer care Guarantee Conditions European Guarantee Instructions for installation and electrical connection Safety instructions for the installerFront view and side view Rear viewInstallation UnpackingPositioning LevellingWater drainage Water inlet cold water connection onlyDo not connect to a hot water supply Interest of the environment Electrical connectionsPermanent connection Door Preparation and assembly of the doorBuilding-in HingesMounting the door Counter-magnetDrill four fixing holes see Fig. G See Fig. H With the appliance Installed adjust all four Page