Electrolux 1051 VI fele manual Water inlet cold water connection only, Water drainage

Page 47

Installation

Water inlet (cold water connection only)

Before connect-
ing the hose be
sure to fit the
mesh filter «A»
supplied as per	A
diagram.
Installation
should comply
with local water

authority and building regulations’ requirements.

Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

Do not connect to a hot water supply.

Water drainage

The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic “U-Piece” supplied. The standpipe should have an internal diameter of approximately 38 mm (see dia- gram) thus ensuring there is an air break between the drain hose and standpipe.

When discharging into a stand- pipe ensure that the top of the curve in the hose end is no more than 90 cm (35.4”) and no less than 60 cm (23.6”) above floor level.

3 pin

Max. 90 cm.(35.4")

Min.60 cm.(23.6")

The upright standpipe should have a mini- mum length of 30 cm (12”) from the bottom of the elbow to the top of the pipe (see dia- gram). Make sure that it is designed in such a way that the end of the drain hose cannot be covered with water.

Longer drain hoses are available in lengths of 2.7 and 4 metres from your AEG Service Force Centre.

Min. 30 cm.(12")

38mm.(1/2 ") diameter standpipe

47

Image 47

Contents AUS Erfahrung GUT Dear customer Contents Programme charts Bulding-in Installation Safety instructionsGeneral safety During use Child safetyMachine DisposalPackaging materials Tips for environmental protection Main features of your washing machine Front view Description of the applianceProgramme selector dial Control panelSTART/PAUSE button Delay Start buttonON/OFF button Mains-on lightStain Programme Option buttonsDisplay Extra RinseProgramme progress display Cancelling a programmeOpening the door after the programme has started Altering a programme which is runningBefore the first wash Detergent dispenser drawerSorting out and preparing the laundry Preparing the wash cycleCotton 40 Weight of laundryTypes of fabric and care labels CottonDelicates Which detergent? Detergents and additivesTraditional Powders Which form?Add detergent and additive How to washSwitching the machine on Load the laundrySelection of the Extra Rinse and/or Rinse Hold option Selection of the desired wash programmeSelection of the spin speed Starting the programme Selection of the Delay Start optionAt the end of the programme Wash programmes Programme chartAdditional Max Duration Dry Special programmesDetergent dispenser drawer Cleaning and maintenancePeriodical cleaning Exterior After each washWater inlet filter Drain filterEmergency emptying out Frost precautionsSomething not working? TroubleshootingProblem Noisy Feet have not been Problem Possible cause Solution White residue is left on the laundry Unsatisfactory washing resultsIf grey stains remain on the laundry Foam is still visible even after the last rinseThis appliance complies with the following EC directives Technical dataHelp us to help you Service & Spare PartsService & Spare Parts 0990 929Customer care Guarantee Conditions European Guarantee Safety instructions for the installer Instructions for installation and electrical connectionRear view Front view and side viewUnpacking InstallationLevelling PositioningDo not connect to a hot water supply Water inlet cold water connection onlyWater drainage Electrical connections Interest of the environmentPermanent connection Hinges Preparation and assembly of the doorBuilding-in DoorCounter-magnet Mounting the doorDrill four fixing holes see Fig. G See Fig. H With the appliance Installed adjust all four Page