Electrolux 1051 VI fele manual Problem

Page 34

Something not working?

Problem

The machine does not fill

The machine fills then empties immediately

The machine does not empty and/or does not spin

There is water on the floor

Possible cause	Solution
The water tap is closed (E00).	Open the water tap.
The water inlet hose is	Check the whole length of the
squashed or kinked (E00).	hose and remove the kink.
The small filter of the water	Clean the filter.
inlet hose is clogged (E00).
The door is not properly	Close the door.
closed (E20).
The end of the drain hose	Place the hose at the right
is too low.	height (see Installation
	section).
The drain hose is	Check the whole length of
squashed or kinked (E10).	the hose and remove the
	kink.
The drain filter or the	Clean the filter or check
drain hose are clogged (E10).	the hose.
The RINSE HOLD option	Empty out the water by
(stop with water in drum)	pressing the START button
has been selected.	or selecting the PUMP OUT
	programme.
The laundry is not evenly	Redistribute the laundry
distributed inside the drum.	manually in the drum.
Too much detergent has	Measure detergent
been used.	according to the
	manufacturer’s instructions.
An unsuitable detergent	Use a suitable washing
has been used that	machine detergent.
creates too much foam.
One of the connectors on	Check that the hose is
the water inlet hose is	firmly screwed on at both
leaking.	ends.
The drain filter has not	Fully screw the filter into
been properly screwed on	place.
after cleaning.

34

Image 34

Contents AUS Erfahrung GUT Dear customer Contents Programme charts Bulding-in General safety Safety instructionsInstallation Child safety During usePackaging materials DisposalMachine Tips for environmental protection Main features of your washing machine Description of the appliance Front viewControl panel Programme selector dialMains-on light Delay Start buttonON/OFF button START/PAUSE buttonProgramme Option buttons StainExtra Rinse DisplayCancelling a programme Programme progress displayAltering a programme which is running Opening the door after the programme has startedDetergent dispenser drawer Before the first washPreparing the wash cycle Sorting out and preparing the laundryCotton Weight of laundryTypes of fabric and care labels Cotton 40Delicates Detergents and additives Which detergent?Which form? Traditional PowdersLoad the laundry How to washSwitching the machine on Add detergent and additiveSelection of the spin speed Selection of the desired wash programmeSelection of the Extra Rinse and/or Rinse Hold option Selection of the Delay Start option Starting the programmeAt the end of the programme Programme chart Wash programmesSpecial programmes Additional Max Duration DryAfter each wash Cleaning and maintenancePeriodical cleaning Exterior Detergent dispenser drawerDrain filter Water inlet filterFrost precautions Emergency emptying outTroubleshooting Something not working?Problem Noisy Feet have not been Problem Possible cause Solution Foam is still visible even after the last rinse Unsatisfactory washing resultsIf grey stains remain on the laundry White residue is left on the laundryTechnical data This appliance complies with the following EC directives0990 929 Service & Spare PartsService & Spare Parts Help us to help youCustomer care Guarantee Conditions European Guarantee Instructions for installation and electrical connection Safety instructions for the installerFront view and side view Rear viewInstallation UnpackingPositioning LevellingWater drainage Water inlet cold water connection onlyDo not connect to a hot water supply Interest of the environment Electrical connectionsPermanent connection Door Preparation and assembly of the doorBuilding-in HingesMounting the door Counter-magnetDrill four fixing holes see Fig. G See Fig. H With the appliance Installed adjust all four Page