Electrolux 1051 VI fele manual Mounting the door, Counter-magnet

Building-in

c) Mounting the door

Fix the hinges (1) to the machine by means of the M5x8 screws (3-Fig. B). The hinges can be adjusted to compensate for possible uneven thick- ness of the door.

To align the door perfectly it is necessary to loosen the screw (3-Fig. B), adjust the door and tighten the screw again.

d) Counter-magnet (6)

The appliance is pre-arranged for a magnetic closure of the door. To enable a correct oper-

ation of this device, it is necessary to screw	6
the counter-magnet (6) (steel disk + rubber	4
ring) into the inner side of the door.

Its position must correspond to the magnet (4) on the appliance (see picture D).

D8

If the door has to be opened from left to right, invert the position of

the plates (7), the magnet (4) and 4 the plate (5) (Fig. B and E). Mount

the countermagnet (6) and the hinges (1) as previously described.

5

Important: the plastic screw (8) should never be loosened (Fig. B and E).

E

7

3

6

1

8

2

51