Before using for the first time
Before the washer is used for the first time, it needs to be properly installed and connected. See "Installation and connection".
Because the washer was put through a complete operational test in the factory, there will be some water left in the drum.
For safety reasons, the washer will not spin until it has been prepared for use. To activate the spinning function, you will need to run a wash programwithout laundry and without detergent.
If you use detergent, it will cause excessive sudsing.
This preparation step also activates the ball valve in the drain. Once activated, the ball valve helps prevent detergent escaping from the suds container into the drain during a wash program, thus ensuring maximum use of the detergent.
Press the
If the washer is being switched on for the first time, the welcome screen will appear.
The welcome screen will appear in the display every time the washer is switched on, until a program lasting longer than 1 hour has been completed.
Setting the language
You will be prompted to select the desired display language. You can change the language at any time through the programmable functions.
deutsch
Turn the program selector to select the desired display language. Use the Start/Stop button to confirm your selection.
Reminder to remove the shipping rods
The shipping rods must be removed before the washer is used for the first time, to help prevent damage to the appliance.
After removing the shipping rods, press the Start/Stopbutton.
Running the washer for the first time
Run aCotton 60°C with no laundry and no detergent. (This program is automatically selected.)
Open the faucets.
Press the Start/Stopbutton.
Once the program is finished, switch the washer off.
The washer is now ready for regular use.
12