Important safety instructions
Technical safety
Check the washer for externally visible damage before installation. Do not install or operate a damaged washer.
Before plugging in the appliance, you must make sure that the electrical rating (fuse amperage, voltage and connected load in watts, indicated on the data plate) matches the household electrical supply. If in any doubt, consult a qualified electrician.
The washer can only be considered safe if it has been connected to a properly installed grounding system, as per code.
It is crucial to have this essential safety requirement tested, and to have the household wiring checked by a professional if there is any doubt. Miele will not be held liable for any damage or harm caused by a missing or incomplete grounding system.
For safety reasons, do not use extension cords (danger of fire from overheating).
Use only genuine Miele replacement parts to replace defective components. Only these parts are guaranteed to meet applicable safety requirements.
Unauthorized repairs may create unforeseeable risks for the user, for which Miele assumes no liability.
Repairs should be carried out only by authorized Miele technicians - otherwise, associated damage will not be covered by the warranty.
If the power cord is damaged it must be replaced by an authorized Miele technician to prevent danger to the user.
In the event of a fault, or for care and cleaning, the washer is only considered disconnected from the power supply, when
–the plug is completed removed from the socket, or
–the circuit breaker for the house wiring system is completely shut off, or
–the
Use only a new hose kit to attach the washer to the household water supply. Old hosing should not be
7