Installation and connection
Installation surface
The best installation surface is a cement floor. In contrast to wooden floorboards or other "soft" types of flooring, cement is less prone to vibration during the spin cycle(s).
Please note:
Make sure the washer is standing square on stable footing.
To avoid vibration during spin cycles, do not install the washer on soft floor coverings.
If installing on wooden floorboards:
Stand the washer on a plywood base (at least 59x52x3 cm). The base should span several joists and will need to be bolted to the joists, NOT just into the floorboards.
It is best to install the washer in the corner of a room. This is typically the most stable part of the floor.
If the washer is being installed on a raised plinth, it MUST be secured against slippage using retaining clips (contact your Miele dealer or Miele Customer Service). Otherwise, the washer may fall off the platform during spinning.
Transporting the washer to the installation site
To remove the washer from the packing case to the installation site, hold it by the front feet of the appliance and the edge of the lid that protrudes from the rear of the machine.
Make sure the feet and the installation surface are dry, to prevent slipping during spinning.
Removing the transport fittings
Remove the left and right covers.
1. Use a screwdriver to pry the covers loose as shown.
2. Pull forward to remove.
44