Miele W 1612 Fault messages in the display, Problem Possible cause Remedy Display lights up

		Troubleshooting
Fault messages in the display
Problem	Possible cause	Remedy￿
The display lights up ￿	– The water outlet is	– Clean the drain filter and
and	restricted or	pump.
Drain fault	blocked.	– The max. drain pump
flashes.	– The drain hose is	height (delivery head) is
	sitting too high.	1m.
The display lights up ￿	The water inlet is	Check whether:
and	blocked or restricted.	– the stopcock is open
Water inlet fault		enough.
flashes.		– the inlet hose is pinched or
		bent.
		– the water pressure is too
		low.
The display lights up ￿	The water protection	Call the service department.
and	system was triggered.
Waterproof fault
flashes.
The display lights up ￿	There is a fault.	Re-start the program.
and		If the fault message appears
Technical fault		again, call Customer Service.
flashes.
The display flashes	Excessive foam has	Use less detergent next time,
Anti-crease	built up during	and check the recommended
Chk detergent	washing.	doses on the package.

￿To switch off the fault message: Use the I-On/0-Offbutton to switch the washer off.

35