Miele 05 536 980 operating instructions Use

Page 9

Warning and safety instructions

This machine must only be con- nected to the on-site water supply

using a new hose kit. Old hoses must not be re-used. Check the hose regu- larly for signs of wear and tear. Change in good time to avoid the risk of leaks and subsequent damage.

Faulty components must only be exchanged for Miele original spare

parts. Only when these parts are fitted can the safety standards of the ma- chine be guaranteed.

In countries where there are areas which may be subject to infestation

by cockroaches or other vermin, pay particular attention to keeping the appli- ance and its surroundings in a clean condition at all times. Any damage which may be caused by cockroaches or other vermin will not be covered by the appliance guarantee.

Use

This equipment is not designed for maritime use or for use in mobile

installations such as caravans, aircraft etc. However it may be suitable for such usage subject to a risk assess- ment of the installation being carried out by a suitably qualified engineer.

Do not install your washing ma- chine in rooms where temperatures

below freezing may occur. Frozen hoses may burst under pressure. The reliability of the electronic control sys- tem may be impaired at temperatures below freezing point.

Before using the machine for the first time, check that the transit fit-

ting at the rear of the machine has been removed (see section on "Installation"). During spinning, a transit fitting which is still in place may result in damage to both the machine and adjacent furni- ture or appliances.

Turn off the stopcock if the ma- chine is to be left for any length of

time (e.g. holiday), especially if there is no floor drain (gully) in the immediate vicinity.

Flooding danger.

If hooking the drain hose into a wash basin, check that the water can drain off quickly enough to prevent the sink from overflowing.

Make sure the drain hose is secure, so that the force of the water flowing out of the hose does not dislodge it. Other- wise this will result in flooding.

Take care to ensure that foreign ob- jects (e.g. nails, needles, coins,

paper clips, etc.) do not find their way into the machine with the washing (e.g. in pockets). Foreign objects can dam- age components of the machine, which in turn can result in damage to the washing.

9

Image 9
Contents Premier Novo Caring for our environment Disposal of the packing materialDisposal of your old appliance Contents Contents Consumption data Technical Data Front view Guide to the machineControl panel Correct usage Technical safetyUse Disposal of your old machine AccessoriesWashing environmentally and economically Before using for the first time Water hardness reminder dialFlushing out the machine Brief guide How to wash correctlyBefore washing ASort the laundry Pre-treat the laundryBPress the Door button CLoad the drum Maximum load weights are noted be- lowEOpen the stopcock FAdd detergent To start a programme GPress in the I-ON/0-OFF buttonJSelect a spin speed ISelect any additional option re- quiredMemory-Function KPress the Start buttonAt the end of a programme General exceptions Adding or removing washing after programme startInterruption ProgrammeAlteration Skipping a programme stageIt is important to dispense the correct amount, because Adding detergentWater Hardness Too little has the following resultsFabric conditioners, texturisers, liquid starch Adding detergent Water softenersStarching separately Separate fabric conditioner or texturiserProgramme selection ProgrammesProgrammes COTTONS1 Minimum Delicates Woollens IRON1 SequenceQuick Wash Starch Spin Select the appropriate temperature ac Important other care symbols Tumble dryIroning Soak Additional optionsPre-wash ShortSwitching off the additional options Water plusSpin Switching off programme locking early Switching on programme lockingTo check if programme locking is switched on Electronic programme lockingMaximum water level Programmable functionsOption Water plus systemSelecting the Options Activating the i compartment Soak time Woollens ColdSelecting a different Soak time Gentle action Woollens 40 C ActivatingStoring the programmable function in memory Top-up rinse for Cottons Memory function Deactivating the programmable func- tionReactivating Cleaning the washing machine Cleaning and careExtra cleaning ClothCleaning the detergent dispenser drawer Cleaning the fluff drain filter and pump After cleaning To clean the filter in the water inlet valve To clean the water inlet filtersProgramme does not start Problem solving guideWash programme stops and a fault indicator light comes on Cator light flashes FlashesProgramme sequence dis PlayGeneral problems or an unsatisfactory wash result Strange noises What to do if Possible cause Remedy Pump makesLarge residues of de Tergent remainCles cling to What to do if Possible cause Remedy Grey, greasy partiWashed laundry There are white resTo check water pressure Opening the drum door in the event of a power failureFuture updates PC After sales serviceAppliance guarantee Customer contactInstallation surface InstallationInstallation Removing the transit fittingRe-fitting the transit bars Levelling the machine Screwing out and adjusting the feetWasher and Dryer stack Building under a worktopConnection to water supply Drain hose connection Connection to the drainage systemElectrical connection U.K Electrical connection U.K Non-rewireable plugs BS Consumption data Technical Data Page Page Alteration rights reserved/3002