Cabletron Systems EMM-E6 manual Document Conventions

Page 11

Document Conventions

1.3DOCUMENT CONVENTIONS

The following conventions are used throughout this document:

NOTE

Note symbol. Calls the reader’s attention to any item of information that may be of special importance.

!

C AUT IO N

Caution symbol. Contains information essential to avoid damage to the equipment.

Electrical Hazard Warning symbol. Warns against an action that could result in personal injury or death due to an electrical hazard.

Figures throughout the document are identified by chapter and illustration number. Many figures contain small numbers at the lower right-hand corner of the illustration. These are Cabletron Systems document control numbers and are not essential to an understanding of the document.

References to chapters or sections within this document will be printed in boldface type.

References to other publications or documents will be printed in italic type.

EMM-E6 Installation Guide

1-3

Image 11
Contents EMM-E6 Ethernet Bridge Management Module Installation GuidePage EMM-E6 Installation Guide DOC Notice Cabletron Software Program License Declaration of Conformity Contents Adding Epims EMM-E6 Overview HOW to USE this ManualChapter Introduction Introduction Following conventions are used throughout this document Document ConventionsGetting Help Related DocumentsFaceplate Chapter Controls and IndicatorsInternal Components Internal Components Epim Connector Pins Ldram Simm Slot Lanview Leds Reset CPU B a Stby RCV XMT CLNLanview Leds EMM-E6 Installation Guide Unpacking the EMM-E6 Chapter InstallationPerform a second visual inspection of the module EMM-E6 Dip Switches Setting Mode SwitchesEMM-E6 Installation Guide PRE-INSTALLATION Test Pre-Installation Test Configuration Install the EMM-E6 into the MMAC-FNB backplane as follows InstallationModule Guide Channels Reset CPU B a Stby RCV XMT CLN Connecting a 10BASE-T Segment to an EPIM-T Connecting to the NetworkPosition X crossed over RX+ TX+ Position = Not crossed over Cable Pinouts RJ45 Port Connecting a 10BASE-F Segment to an EPIM-F2 or EPIM-F3 ST Connector Insertion Connecting a 10BASE-F Segment to an EPIM-F1 SMA Connector Insertion EPIM-A Connecting an AUI Segment to an EPIM-X orConnecting a 10BASE2 Segment to an EPIM-C 10 BNC Connector Insertion 11 Backplane Test Configuration Backplane TestUsing Lanview Leds Chapter TroubleshootingTroubleshooting Using Lanview Leds Troubleshooting Checklist Troubleshooting Checklist EPIM-A Using the Reset Switch EMM-E6 Installation Guide Operating Specifications Appendix a SpecificationsPhysical Specifications COM Port Pinout Environmental RequirementsCertification Appendix B Upgrading the EMM-E6 Locating Brim ConnectorsAdding Epims To install an EPIM, perform the following stepsLocating SIMMs Simm UpgradesFigure B-3, refer to the procedures below Installing SIMMs1 10BASE-T Twisted Pair Network Appendix C Ethernet Cabling RequirementsNetwork Requirements Appendix C Ethernet Cabling Requirements Multimode Fiber Optic Network Single Mode Fiber Optic Network Transceiver Requirements 4 10BASE2 Coaxial Cable NetworkEMM-E6 Installation Guide Numerics IndexIndex-2 EMM-E6 Installation Guide Lanview LEDs EMM-E6Installation
Related manuals
Manual 118 pages 2.72 Kb