Allowable Clearances for Undercounter Installation
The dimensions are for the recommended spacing. Counter depth should be
Custom undercounter installation – Washer only
Minimum counter width should be 50” (127 cm) for a pair of Blomberg washer & dryer.
Custom undercounter installation – Washer & Dryer
A louver having minimum 23 in2 (148 cm2) air opening located at 3 in (7.62 cm) height from the bottom of closet door (for washer) & A louver of minimum 46 in2 (297 cm2) air opening located at 3 in (7.62 cm) distance from the top of closet door (for dryer).
Removing packaging reinforcement
Tilt the washer to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon.
50”
(127 cm)
Allowable Clearances for Closet Installation
When installed in closet (washer only/ washer dryer stacked) :
Sides, Rear, Front 1/2 in. (1.27 cm), Top= 1 in. (2.54 cm)
Closet door ventilation requirement: A louver having minimum 23 in2 (148 cm2) air opening located at 3 in (7.62 cm) from the bottom of closet door.
Stacked Installation
You can stack your Blomberg washer and dryer (model no: DV 16540 NBL00) by using a special stacking kit (Part No.2967100100). If necessary, consult your dealer or technical service for supplying the stack kit. In stacked closet installation, following configuration is necessary:
Removing shipping bolts
A WARNING - Shipping bolts must be removed before operating the washer! Otherwise, the appliance will be damaged seriously!
1.Loosen all the bolts with a spanner until they rotate freely (“C”)
10
EN