Blomberg WM 87120 NBL00 installation instructions Lcd

Page 33

 

Inlet hose connections may be

Be sure the strainers and rubber

 

seals of the water inlet hoses are

 

leaking.

 

solid and securely fitted.

 

 

 

 

 

 

End of the drain hose may be

Tightly attach the drain hose to the

 

loosely inserted into the waste

waste pipe or sink (See “Installation

 

pipe or sink.

Instructions, Drainage”).

There is water coming

 

 

 

If the house drain pipes are clogged,

from the bottom of the

House drain may be clogged.

washer.

call a plumber for assistance.

 

 

 

 

 

Filter cap of the drain pump may

Make sure that the pump filter cap is

 

not be properly fitted.

tightly closed.

 

 

 

 

 

Internal hose connections (e.g.

 

Hose connections inside the

dispenser hoses, drain system)

 

washer may be leaking.

should be checked by a service

 

 

technician.

 

 

 

Washer fills with water

There may be hot water inside

For safety reasons, water should be

when a process is

washer.

cycled in and out a couple times.

cancelled.

 

 

Time delay function

Door may not be closed properly.

Close the loading door.

does not work.

 

 

 

 

 

 

Water level might be above the

Run “Drain” , “Spin” or “Drain&Spin”

 

lower level of the door.

program.

 

 

 

 

Washer might be heating up the

 

 

water or it may be at the spinning

Wait until the process is over.

The door will not open.

cycle.

 

 

 

 

Due to electrical safety

 

 

mechanism, the door can only be

Wait until the process is over.

 

opened a few minutes after the

 

 

 

program has stopped.

 

 

 

 

The door will not lock/

Door is not properly closed/Door

Push the loading door firmly shut

door expression is on

hinge is not aligned with lock

until you hear it lock into space

LCD

switch.

 

 

 

 

33

EN

Image 33
Contents Front-Loading Automatic Washer WM 87120 NBL00 Explanation of symbols Please read this guide firstThis guide will… Table of Contents Overview Your WasherSpecifications Important Safety Instructions Page Page Installation Instructions Right Location InstallationInstallation Clearances Allowable Clearances for Closet Installation Allowable Clearances for Undercounter InstallationStacked Installation Removing packaging reinforcementLevelling the washer Electrical ConnectionGrounding Instructions Water Supply Connection Power supply and circuitDrainage Installation ChecklistDisposal Information TransportationAppliance Disposal Packing DisposalFirst Use Operating InstructionsLaundry Tips Before the first useLoading the washer Preparing the laundryDetergent Quantity Detergent UseLiquid Chlorine Bleach Compartment Water ConsumptionDisplay symbols Selecting a Program and Operating Your WasherControl panel Program cycle selection Turning the washer onWash Cycles Additional programsTemperature selection Special programsSpin Speed selection Program Cycle Selection Table Auxiliary Function Selection Buttons Auxiliary functionsSoak Extra RinseChanging the delay time Time delayCanceling the time delay Time displayStarting the Program Switching the washer to standby modeProgress of program Changing the selections after the program has startedEnding the program through canceling Child-proof lockEnd of program Preparation Canceling a programStarting Adding more laundryRe-spinning the laundry If you want to discharge the water without spinningCleaning detergent dispenser User maintenance instructionsCleaning the door seal Cleaning the outer cabinet and control panelCleaning the drain pump filter Cleaning the water inlet strainersDescaling the washer Troubleshooting LCD Washer will wait until there is a Automatic spin correction Laundry in the drum. No spinning Do not load the washer in excess Insufficient amount of detergent can Laundry in the machine. The laundry Be clogged Start/Pause/Cancel button for a short Warranty Statement for the Blomberg Clothes Washers HOW to GET Service