INSTALLATION INSTRUCTIONS
Toolsand Parts
Gather the required tools and parts before starting installation. Read and follow the safety instructions provided with any tools listed here.
Options
Pedestal
■
■#2 Phillips screwdriver
■Adjustable wrench that opens to 1" (2.5 cm) or
■¼" nut driver (recommended)
■Wire stripper (direct wire installations)
■Level
■Vent clamps
■Caulking gun and compound (for installing new exhaust vent)
■Tin snips (new vent installations)
Are you placing the dryer on a pedestal? You may purchase a pedestal separately for this dryer. This pedestal will add about 13" (33 cm) to the height of your unit for a total height of approximately 51" (130 cm).
For a garage installation, you will need to place the pedestal at least 6" (15.2 cm) above the floor.
Parts supplied
Remove parts packages from dryer drum. Check that all parts are included.
4 Leveling legs
NOTE: Do not use leveling legs if installing the dryer on a pedestal.
Parts needed
Check local codes. Check existing electrical supply and venting. See “Electrical Requirements” and “Venting Requirements” before purchasing parts.
■For
37"
(93.98 cm)
Mobile home installations require metal exhaust system hardware available for purchase from the dealer from whom you purchased your dryer. For further information, please refer to the “Assistance or Service” section of this manual.
Optional pedestal
To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or Service” section of this manual. Ask for Part Number LAB2700PMT (Meteorite) or LAB2700MQ0 (White).
Stack Kit
Are you planning to stack your washer and dryer? To do so, you will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or Service” section of this manual. Ask for Part Number 8541503.
4