Samsung DC68-02657F user manual Connections at the water valve and the faucet for leaks

setting up your washer

3. Check the inlet hose to ensure a washer is inside each fill hose.		Cold
Thread the inlet hoses to the HOT and COLD faucet
connections.
On the other end of the hose, check for one rubber washer per
hose and install each fill hose to the water valve. Make sure the
hose with the Hot printed line is attached to the HOT faucet.
Tighten by hand until snug, then two-thirds of a turn with pliers.
For correct water use, connect both HOT and COLD water
valves. If either or both are not connected, an “nF” (no fill) error
can occur.
4. Turn on the HOT and COLD water supply and check all	Cold printed
connections at the water valve and the faucet for leaks.

Hot

Hot printed

5.Plug the power cord into a 3-prong, well grounded 120 volt 60 Hz approved electrical outlet protected by a 15-amp fuse or comparable circuit breaker.

Your washer is grounded through the third prong of the power cord when plugged into a three-prong grounded receptacle.

6.Slide your washer into position.

7.Level your washer by turning the leveling legs in or out as necessary by hand or by using the wrench included with your washer.

When your washer is level, tighten the locking nuts using the wrench or (-) flathead screwdriver.

Your washer must be leveled on all four sides. A carpenter’s level should be used on all four corners of your washer. It’s the best to recheck after the first dozen washes.

Locking

Nut

Levelling

Leg

Avoid damage to the legs. Do not move the washer unless the locking-nuts are fastened to the bottom of the washer.

16_ setting up your new washing machine

WF410AN-02657F_EN.indd 16

2010-04-29 ¿ÀÈÄ 3:55:52