Installation
3.6 Connecting to the drain
• Connect the end of the drain hose directly to the wastewater drain, sink or to the washbasin.
CAUTION
¾¾ Your house will be flooded if the hose comes out of its housing during A water discharge. Moreover, there is risk of scalding due to high washing temperatures! To prevent such situations and to ensure smooth water intake and discharge of the machine, fix the end of the discharge hose
tightly so that it cannot come out.
90cm
90 | 90 cm |
| |
60 | 60 |
|
•The distance to the wall so that the machine be placed up to 30 cm.
•Attach the hose at a height of at least 60 cm, and 90 cm at most.
•In case the hose is elevated after laying it on the floor level or close to the ground (less than 60 cm above the ground), water discharge becomes more difficult and the laundry may come out excessively wet. Therefore, follow the heights described in the figure.
•To prevent flowing of waste water back into the machine and to allow for easy discharge, do not immerse the hose end into the waste water or do not drive it in the drain more than 15 cm. If it is too long, cut it short.
•Pay care not to bend the end of the hose, step on it or pinch the hose between the drain and the machine.
•If the length of the hose is too short, use it by adding an original extension hose. Length of the hose may not be longer than 3.2 m. To avoid water leak failures, the connection between the extension hose and the drain hose of the product must be fitted well with an appropriate clamp as not to come off and leak.
18 / EN | |
|
|