Maintenance and cleaning
6.5 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the machine and also at the end of each water intake hose where they are connected to the tap. These filters prevent foreign substances and dirt in the water to enter the washing machine. Filters should be cleaned as they do get dirty.
1Close the taps.
2Remove the nuts of the water intake hoses to access the filters on the water intake valves. Clean them with an appropriate brush. If the filters are too dirty, take them out by means of pliers and clean them.
3Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean thoroughly under running water.
4Replace the gaskets and filters carefully in their places and tighten the hose nuts by hand.
6.6 Draining remaining water and cleaning the pump filter
The filter system in your machine prevents solid items such as buttons, coins and fabric fibers clogging the pump impeller during discharge of washing water. Thus, the water will be discharged without any problem and the service life of the pump will extend.
If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned whenever it is clogged or in every 3 months. Water must be drained off first to clean the pump filter.
In addition, prior to transporting the machine (e.g., when moving to another house) and in case of freezing of the water, water may have to be drained completely.
| CAUTION |
A | ¾¾ Foreign substances left in the pump filter may damage the machine or |
may cause noise problem. | |
¾¾ If the product is not in use, turn the tap off, detach the supply hose and | |
drain the water inside the machine against any freezing possibility in the | |
| region of installation. |
| ¾¾ After each use close the supply hose tap of the product. |
User’s Manual | 55 / EN |
|
|