42Daily use
The 
icon appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end.
If you want to set a new programme, you must first deactivate the child safety device.
Starting the programme
Press the START PAUZE button. The programme is started.
The programme phase is shown in display by appropriate icons. From left to the right, from drying 
,anticrease 
, to cooling
.
Changing programme
To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to UIT (off) position. The programme is cancelled.
The programme can no longer be changed directly once the programme has started. If nevertheless there is an attempt to change the programme on the programme knob or if an function button (excluding the ZOEMER (buzzer) button) is pressed, led above START PAUZE button starts flashing temporarily in yellow. The drying programme is not however affected by this (laundry protection).
Putting in extra items or taking items out before end of programme
1. Open loading door.
WARNING!
Laundry and drum can become hot. Risk of burns!
2.Load or remove laundry items.
3.Close loading securely. Lock must audibly lock.
4.Press the START PAUZE button to continue the drying cycle.
Drying cycle complete / removing laundry
Once the drying cycle is complete, display shows a blinking "0", under 
and filter 
icon appear dash. If the ZOEMER (buzzer) button has been pressed, an acoustic signal sounds intermittently for about one minute.
The drying cycles are automatically followed by an 
function has been selected, the
1.Open door.
2.Remove laundry.
3.Remove filter after clothes has been removed. Clean the filter.
WARNING!
Before You place the filter, please check it there is nothing inside the filter seat. 4. Turn the programme selector to UIT (off).
Clean the filter after each drying cycle.