Electrolux T37850 user manual Machine settings, Zoemer buzzer Signal permanent off, Water hardness

46Machine settings

Check the correct positioning of o-ring gasket before screwing back the door light cover. Do not operate the dryer when missing o-ring gasket on door light cover.

WARNING!

For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer must not be operated.

Machine settings

ZOEMER (buzzer) SIGNAL permanent off

1.Turn the programme selector to any programme.

2.Press simultaneously theDELICAAT (delicate) and SENSITIVE buttons and hold down for approx. 5 seconds.

3.The buzzeris by default always off. You can use ZOEMER (buzzer) button to activate or deactivate sound but machine does not memorize your selection.

Water hardness

Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to geographical locations thus varying its conductivity values. Relevant varia- tions of the conductivity of the water compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the water.

1.Turn the programme selector to any programme.

2.Press simultaneously the DELICAAT (delicate) and TIJD PROGR. (time) buttons and hold

down for approx. 5 seconds. The current setting is on the display:		– low con-
ductivity <300 micro S/cm,	– medium conductivity 300-600 micro S/cm,
– high conductivity >600 micro S/cm

3.Press the START PAUZE button sequentially until you set desired level.

4.To memorize setting press simultaneously the DELICAAT (delicate) and TIJD PROGR. (time) buttons or turn knob to UIT (off) position