
Daily use 41
ANTIKREUK LANG (long anticrease)
A long anticrease phase lengthen the
When the option is active, the ANTIKREUK LANG (long anticrease) icon is on.
ZOEMER (buzzer)
The appliance is supplied with the ZOEMER (buzzer) function deactivated. To activate ZOEMER (buzzer) choose ZOEMER (buzzer) option.
The ZOEMER (buzzer) sounds or plays a tune during:
–cycle end
–
–cycle interruption by a warning
–alarm
TIJD PROGR. (time)
To select the programme duration after setting the TIJD PROGR. (time) programme. You can select a programme duration from 10 mins to 3 hrs in
1.Turn the programme knob to the TIJD PROGR. (time) programme.
2.Press the TIJD PROGR. (time) button repeatedly until the desired programme duration is shown in the display, e.g. 20 for a programme of 20 minutes.
If the programme duration is not selected, the duration is automatically set to 10 mins.
Setting delay timer
With the STARTUITSTEL (delay) button, you can delay the start of a programme by between 30 minutes (30') and a maximum of 20 hours (20h).
1.Select the programme and additional functions.
2.Press the STARTUITSTEL (delay) button as many times as necessary until the required start delay appears on the display, e.g. 12h if the programme is to be started in 12 hours.
If the display is showing 20h and you press the button again, the time delay will be cancelled. The display will show 0' and then the duration of the selected pro- gramme.
3.To activate the delay timer, press the START PAUZE button. The amount of time re- maining until the programme is set to start is continuously displayed (e.g. 15h, 14h, 13h, … 30' etc).
Setting child lock
The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. The child lock function locks all buttons and the programme knob. The child lock can be activated or deactivated by holding down the ANTIKREUK LANG (long anticrease) and ZOEMER (buzzer) buttons simultaneously for 5 seconds.
– Before programme is started: Appliance cannot be used
– After programme is started: Programme in operation cannot be changed