Electrolux T37850 user manual Changing the bulb for interior lighting, Section

		What to do if ...	45
		Re-programme standard set-
	Conductance of water at in-
		ting for degree of drying (see
	stallation site differs from
		‘Programming options’ chap-
	standard setting of machine.
		ter).
Loading door does not close.	Filter not in place.	Install filter into place.
When a button is pressed, Err	Washing protection. After the	Turn the programme knob to
	start of the programme, the	UIT (off). Set the programme
appears on the LCD.
	option can no longer be set.	again.
	Programme selector in UIT (off)	Turn programme selector to
		LICHT AAN (light) or to any pro-
Drum light does not work.	position.	gramme.
		Replace light bulb (see next
	Defective light bulb.
		section).
Displayed programme time	Programme time is corrected
	automatically depending on	Automatic process; this is not a
changes erratically or stays un-
	type and volume of laundry	machine fault.
changed for a long time.	and level of dampness.
	Not enough washing loaded or	Select time programme or
Drying cycle ends shortly after		higher drying level (e.g. EXTRA
programme starts.	washing loaded is too dry for	DROOG (extra dry) instead of
	selected programme.
		KASTDROOG (stroage dry)).
	Filter clogged.	Clean filter.
	Load volume too big.	Reduce load volume.
Drying cycle lasts an unusually	Laundry insufficiently spun.	Laundry must be adequately
long time. Note: After around 5		spun.
hours the drying cycle ends au-
	Particularly high room temper-	Automatic process, there is no
tomatically.
	ature. Temporary switching off	fault with the appliance. If pos-
	of the compressor to avoid	sible, lower the room tempera-
	overload.	ture.

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from your local service centre.

When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open.

WARNING!

Do not use standard bulbs! These develop too much heat and may damage the machine! Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse.

1.Unscrew cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)

2.Replace defective bulb.

3.Screw cover back down.