Installation 49
3. Remove foil hose and polystyrene pad- ding from the machine.
Fitting the vent hose
To simplify the installation, there is a choice of vent outlets: one at the back, the others in the left and
If the hose is long and the room temperature low,
the moisture might condense to water inside the hose. This is an unavoidable natural phenomenon. To prevent this water from Iying in the hose or flowing back into the tumble dryer, it is advisable to drill a small hole (via. 3 mm) in the lowest point of the hose and to place a small container below
it. (See picture, point B). Once connected to the dryer, run the vent hose to the desired outlet point, ensuring that the run’s overall length is less than 2 m, and that it contains no more than two bends. As to the outlet itself, if you have decided on a fixed wall/window grille, a
good local builder’s merchant should be able to
supply you with the necessary fittings and installation advice.