GE K400 user manual Voltage Measurements high level

Page 49

Voltage Measurements (high level)

The DBC-TC series can measure a voltage signal from temperature transmitters under test.

REF T.

INTERNAL

SEL RTD

MEASURE

mV

Ohm

V

From the Menu Selection Screen, select V in the MEASURE section using the keys and press ent. After selection of the temperature generation mode to be used, the next display allows set-up of the voltage measurement method.

MODE

DIRECT

CAL

•Direct

Use the keys and pressing ent, changes the display to the working screen. The top part of the working screen shows the voltage signal from the unit under test in the top part and the parameters of the generated temperature in the bottom part.

VOLT	10.00
RDG:	10.00	V
150.00		DIRECT
BLK	148.00
	148.00	°C

K400 Issue No. 1

39

Image 49

Contents Druck DBC 150/650 Series General Electric Company. All rights reserved Power isolation SafetyMaintenance Technical AdviceTraceability and Calibration Report SymbolsAbbreviations Safety InstructionsTable of Contents CAL Electrical Input Specification DBC-TC models Optional Accessories DBC-TC series Standard Accessories DBC-TC seriesOptional Accessories DBC-TS series Standard Accessories DBC-TS seriesTC Temperature Calibrator TS Temperature SourceIntroduction Parts Identification Automatic CalibrationDBC-TS Power Supply InstallationTemperature Probes Important Note Electrical Connections Connection of a Thermocouple sensor Use of screw connections for T/C wiresConnection of a 4-wire RTD Connection of a 3-wire RTDGeneral Operating procedureCalibration with external reference probe External probe connections OPERATI0N Key +/- keyNumeric keys Arrow keysSystem Set-up Screen Menu selection screenWorking screen Self-test screen Help/Info screenDual display generated temperature and an input test option Function Modes Reading of the generated temperatureInternal reference probe Temperature Reference SelectionExternal reference probe SEL RTD Temperature unit setting System Set-up Language settingKey-padaudio signal Digital interface settingsCalibration Printer settingsProtection code 150.00 C Testing Modes Direct modeFixed step selection Step mode19.00 C 50.00 C Ramp modePreset values mode Measuring an Input Switch Test148.00 C Thermocouple TestingInternal Setting Cold Junction CompensationDirect CAL ModeSpan AbsoluteReading RTD Measurements Pt-100 Using the keys, select the required method and press ent Reading Current Measurements CAL Voltage Measurements high level CAL Volt Voltage Measurements low level Resistance Measurement Serial Communication DBC Series Serial Commands ProtocolTS/ TC Read AaOM 1? Preset mode French German Italian Portuguese Spanish Write Par = floating point Important Note CalibrationCalibration of the standard Reference Probe Input REF RTD Calibration of the millivolt input ranges DBC-TC only Calibration of the mA input range DBC-TC only Calibration of the Volt input range DBC-TC onlyCalibration of the resistance Ohm input ranges DBC-TC only Fault Finding Cleaning Instructions MaintenanceStandard Specification Technical SpecificationCommon specification Input Range Resolution Accuracy Days Year Electrical Input Specifications DBC-TC models