Kenmore 3405602 owner manual Three-Wireelectrical, Nei

I. THREE-WIREELECTRICAL

CONNECTION TO RECEPTACLE

Use a 3-wire power supply cord:

Electrical Shock Hazard

Turn power supply off before connecting cord.

Use a new 30-ampere power supply cord.

Plug into a grounded outlet.

Failure to follow these instructions

can result in death, fire, or electrical shock.

Local codes may permit the use of a U.L.-listed, 120/240-volt minimum, 30-ampere, dryer power supply cord kit (pigtail). Power supply cord should be type SRD or SRDT and be at least four feet long.. The wires that connect

to the dryer must end with ring terminals or spade terminals with upturned ends.

Spadeterminals_ ,__ with upturnedends

_Thisbladeconnected Ring

NEI_ to this co_ s

Do not use an extension cord with this dryer.

Do not connect plug end of power supply cord into a live receptacle before connecting power supply cord to dryer terminal block.

GROUNDING INSTRUCTIONS

This appliance must be grounded.

In the event of malfunction or break-

down, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. The power supply cord must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

WARNING: Improper connection of the

equipment-grounding conductor can result in a risk of electric shock. Check

with a qualified electrician or serviceman if your are in doubt as to whether the appliance is properly grounded.

Do not modify the plug on the power supply cord. If it will not fit the outlet, have a proper outlet installed by a qualified electrician.

STEP 1. Turn power supply off.

STEP 2. Remove hold-down screw and terminal block cover.

Hold-downscrew Terminalblockcover

strainrelief (white or center)

Three-wire power supply cord

The power supply cord must have three, No.-10 copper wires to match a three- wire receptacle of NEMA Type 10-30R.

	receptacle
•	(NEMAType
I_	hree-wire
	10-30R)

12