RECESSED AREA/CLOSET
INSTALLATION INSTRUCTIONS
Check governing codes and ordinances.
This dryer may be installed in a recessed area or closet.
Confined or Recessed Area Installation
Exhausting the dryer outside is recom- mended. The moisture and lint indoors
may cause:
•Lint to gather inside and around the dryer and be a fuel for a fire.
•Moisture damage to woodwork, furni- ture, paint, wallpaper, carpet, etc.
•Housecleaning problems and possible health problems.
Recessed installation that is not exhausted outside must use Exhaust Deflector Kit Part No. 3391278. This
kit is available at your local Sears store or Sears Service Center.
Closet Installation
WARNING: To reduce the risk of fire,
this appliance must be exhausted outdoors when installed in a closet.
NOTE: No fuel burning appliances may be installed in the same closet as a dryer.
PRODUCT DIMENSIONS
Location must be large enough to fully open dryer door.
4 _
271/2"
3"
OlO
3"
|
| |
Front View | Side View | FrontView |
(Door Not Shown) | (Door Shownl | (DoorWithVent) |
MINIMUM INSTALLATIONSPACING. Closet installation MIJ_r be exhausted outside. "Additional clearances for waft, door and floor moldings may be required. _' ctearaoce
is acceptable but not recommended.
**Opening is minimum for closet door. Louvered door with equivalent air openings is acceptable.
***Additional space is needed when external exhaust elbow is used• Can be 0" clearance when house exhausting is lined up directly with dryer exhaust.
,,The installation spacing is in inches and is the minimum allowable.
•Additional spacing should be considered for ease of installation
and.,servicing.
•If closet door is installed, the minimum air openings in top and
bottom are required. Louvered doors with equivalent air openings in top and bottom are acceptable.
•Closet installation must be exhausted outside. Other installations must use at least the minimum dimensions indicated.
i