Electrolux EDI97170W user manual Technical data, Changing the bulb for interior lighting

Page 22

22electrolux

Programme inactive, CONTAINER display illu- minated.

Drying cycle ends shortly after programme starts.

ANTICREASE display illuminated.

Drying cycle lasts an un- usually long time. Note: After up to 5 hours the drying cycle ends auto- matically (see ‘End of dry- ing cycle’).

Condensed water container is full.

Not enough washing loaded or washing loaded is too dry for selec- ted programme.

Lint filter clogged.

Fluff filter clogged.

Empty Condensed water contain- er , then start programme with START/PAUSE button.

Select time programme or higher drying level (e.g. EXTRA instead of CUPBOARD).

Clean lint filter.

Clean fluff filter.

Load volume too big.

Laundry insufficiently spun.

Particularly high room temperature. Temporary switching off of the compressor to avoid overload.

Discoloration

Colour fastness of textiles.

 

 

Reduce load volume.

Laundry must be adequately spun.

Automatic process, there is no fault with the appliance. If possible, low- er the room temperature.

Check colour fastness of textiles. Only treat textiles together if they are a similar colour.

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from your local Service Force cen- tre.

Warning! When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open.

Warning! Do not use standard bulbs! These develop too much heat and may damage the machine!

Warning! Before replacing the bulb, disconnect the mains plug.

1.Unscrew cover above the bulb (this can be found directly behind the loading aper- ture, at the top; refer to “Description of machine” section.)

2.Replace defective bulb.

3.Screw cover back down.

Check the correct positioning of o-ring gas- ket before screwing back the door light cov- er. Do not operate the dryer when missing o- ring gasket on door light cover.

Warning! For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer must not be operated.

Technical data

This appliance conforms with the following EU Directives:

2006/95/EC dated 12.12.2006 Low Voltage Directive

89/336/EEC dated 03.05.1989 EMC Directive inclusive of Amending Directive 92/31/EEC

93/68/EEC dated 22.07.1993 CE Marking Directive

Height x width x depth

Drum volume

Depth with loading door open

Height can be adjusted by

85 x 60 x 58 cm

108l

109cm 1.5 cm

Image 22
Contents Iron Aid EDI97170WElectrolux. Thinking of you Contents Important safety informationInstallation UseOld appliance Child safetyEnvironment Packaging materialProduct description Control panel What is shown in the displayBefore first use Sorting laundry Sorting and preparing laundryStarting up for the first time Special notes about Iron AidIron AidTM Steam System Fill water tankWater recirculation system Overview of Iron Aid programmesCotton Synthetics Refresh Select steam level Load LoadStarting an Iron AidTM programme Selecting additional functionsIron Aid programme complete / removing laundry DryingChanging a programme Overview of drying programmesAdditional Starting a drying programme DrynessDrying rack Removing laundry or loading laundry when necessaryDrying cycle complete / removing laundry Cleaning and maintenance Cleaning lint filtersClean the door seal Cleaning the water recirculation valve/ filterEmptying the condensed water container Cleaning heat exchanger Troubleshooting by yourself Cleaning the drumClean control panel and housing What to do ifAfter a IronAid pro Technical data Changing the bulb for interior lightingMachine settings Consumption valuesHints for test institutes InstallationRemoving transport safety packaging Appliance positioningElectrical connection Drying rack unpackingFor easiest unpacking turn the rack upside down Special accessories ServiceGB IE Guarantee/Customer Service Great Britain & Ireland Standard guarantee conditionsExclusions European GuaranteeService and Spare Parts 0870 5 929136906520-01-04082008