Installation
WARNING
Improper connection of the equipment- grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the dryer is properly grounded.
W038
Do not modify the plug provided with the
The dryer has its own terminal block that must be connected to a separate branch, 60 Hertz, single phase circuit, AC (alternating current) circuit, fused at 30 Amperes (the circuit must be fused on both sides of the line). Electrical service for the dryer should be of maximum rated voltage (208 or 240 Volt, depending on heating element) listed on the nameplate. Do not connect dryer to 110, 115, or 120 Volt circuit.
Heating elements are available for field installation in dryers which are to be connected to electrical service of different voltage than that listed on nameplate, such as 208 Volt.
NOTE: Branch circuit wire size requirements to laundry room outlet are shown in Table 4.
Wire Length |
| Wire |
Less than |
| Listed No. 10 AWG |
15 ft. (4.5 m) |
| Copper wire only |
|
|
|
Longer than |
| Listed No. 8 AWG |
15 ft.(4.5 m) |
| Copper wire only |
| Table 4 | |
The power cord connection between wall receptacle and dryer terminal block IS NOT supplied with dryer. Type of power cord and gauge of wire must conform to local codes.
16 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 513005 |