Alliance Laundry Systems DRY710C Lint Filter, Motor Overload Protector, For Energy Conservation

Page 32

Maintenance

Lint Filter

CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. (Refer to Figure 42 for lint filter location.) Cleaning the lint filter is important because a layer or pad of lint on the filter will block the flow of air through the dryer, thus reducing the efficiency of the dryer. The clothes will take longer to dry and energy will be wasted.

The lint filter may be washed if needed. Annually remove lint filter and screw to vacuum the duct under it.

1

D608I

D608I

1Lint Filter

Figure 42

Motor Overload Protector

The dryer’s motor overload protector stops the motor automatically in the event of an overload. After cooling, the overload protector will reset itself. Dryer can be restarted by pressing the START pad. If overload protector cycles again, remove the dryer from use and call the service person to correct the problem.

For Energy Conservation

Make sure the lint filter is always clean.

Do not overload dryer.

Do not overdry clothes.

Remove items to be ironed while still damp.

Large loads of similar fabrics dry the most efficiently. However, dry permanent press in smaller loads to prevent wrinkling.

Use the correct temperature FABRIC SELECTOR setting for the type of fabric being dried.

Locate your dryer so the exhaust duct is as short and straight as possible.

Do not open the door during the drying cycle.

Plan to do your laundry on low humidity days; your clothes will dry faster.

Should you plan to dry several loads, do them one after another, then you do not have to reheat the dryer unit’s interior parts each time.

30

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

513005

Image 32
Contents Clothes Dryer Page What to do if YOU Smell GAS Contents Important Safety Instructions Safety InformationExplanation of Safety Messages Safety Information Metered Models InstallationDimensions Before You Start ToolsInstalling the Dryer Position and Level the DryerArea Description Free Standing/Alcove Closet Installation Connect Dryer Exhaust System ∙ Failure to exhaust dryer properly will void warranty Exhaust DirectionExhaust System Maximum length of 4 in .2 cm diameter rigid metal ductMulti-Dryer Installation Exhaust Requirements Roof No Screen or Cap Wall Cm Minimum Installation Duct Station Minimum Diameter Collector Duct Gas Dryer Only Connect Gas Supply PipeElectric Dryer Only Connect Electrical Plug Grounding InformationWire Length Typical Receptacle Connecting Power Cord with Three-Wire Plug SHUT-OFF BOXConnecting Power Cord with Four-Wire Plug D695I Reinstall nine screws removed in Step Reverse Door, if DesiredWipe Out Inside of Dryer Plug In the DryerElectric Dryer Gas DryerPlug cord into separately fused Recheck Steps Check Heat SourceElectric Dryers Gas DryersAdditional Dryer Security VendingMeter Case Clean Lint Filter OperationOperation Instructions Load LaundrySet Fabric Selector To Insert CardInsert Coins or Card To Insert MoneyIndicator Lights Start DryerCare of Your Dryer MaintenanceLubrication For Energy Conservation Lint FilterMotor Overload Protector Troubleshooting Dryer Symptom Possible Cause/Solution Dryer won’t startContact Information Alliance Laundry Systems Shepard Street Box Ripon, WIPage Installer Checklist Fast Track for Installing the Dryer