Alliance Laundry Systems DRY710C manual Contact Information

Page 34

Contact Information

If service is required, contact the nearest Factory Authorized Service Center.

If you are unable to locate an authorized service center or are unsatisfied with the service performed on your dryer, contact:

Alliance Laundry Systems

Shepard Street

P. O. Box 990

Ripon, WI 54971-0990

U.S.A.

www.comlaundry. com Phone: (920) 748-3121

Date Purchased ___________________________

Model Number ___________________________

Serial Number ___________________________

When calling or writing about your dryer, PLEASE GIVE THE MODEL AND SERIAL NUMBERS.

The model and serial numbers are located on the nameplate. The nameplate will be in the location shown in the illustration below. Please include a copy of your bill of sale and any service receipts you have.

WARNING

To reduce the risk of serious injury or death, DO NOT repair or replace any part of the dryer or attempt any servicing unless specifically recommended in the user-maintenance instructions or in published user-repair instructions that you understand and have the skills to carry out.

W133

If replacement parts are required, contact the source from which you purchased your dryer or contact us at

(920)748-3950 for the name and address of the nearest authorized parts distributor.

1

D063K

1Nameplate

Figure 43

32

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

513005

Image 34
Contents Clothes Dryer Page What to do if YOU Smell GAS Contents Explanation of Safety Messages Safety InformationImportant Safety Instructions Safety Information Dimensions InstallationMetered Models Before You Start ToolsInstalling the Dryer Position and Level the DryerArea Description Free Standing/Alcove Closet Installation Connect Dryer Exhaust System ∙ Failure to exhaust dryer properly will void warranty Exhaust DirectionExhaust System Maximum length of 4 in .2 cm diameter rigid metal ductMulti-Dryer Installation Exhaust Requirements Roof No Screen or Cap Wall Cm Minimum Installation Duct Station Minimum Diameter Collector Duct Gas Dryer Only Connect Gas Supply PipeElectric Dryer Only Connect Electrical Plug Grounding InformationWire Length Typical Receptacle Connecting Power Cord with Three-Wire Plug SHUT-OFF BOXConnecting Power Cord with Four-Wire Plug D695I Reinstall nine screws removed in Step Reverse Door, if DesiredElectric Dryer Wipe Out Inside of DryerPlug In the Dryer Gas DryerPlug cord into separately fused Electric Dryers Recheck StepsCheck Heat Source Gas DryersMeter Case VendingAdditional Dryer Security Operation Instructions Clean Lint FilterOperation Load LaundryInsert Coins or Card Set Fabric SelectorTo Insert Card To Insert MoneyIndicator Lights Start DryerLubrication MaintenanceCare of Your Dryer Motor Overload Protector Lint FilterFor Energy Conservation Troubleshooting Dryer Symptom Possible Cause/Solution Dryer won’t startContact Information Alliance Laundry Systems Shepard Street Box Ripon, WIPage Installer Checklist Fast Track for Installing the Dryer