Alliance Laundry Systems DRY710C manual Connecting Power Cord with Four-Wire Plug

4.Use the three screws from the accessories bag to attach the power cord wires to the terminal block. Refer to Figure 15.

12

Installation

Connecting Power Cord with Four-Wire Plug

NOTE: Four-wire cord is required for new branch- circuit installations, mobile homes or where codes do not permit grounding through neutral.

3

D286I

1

	±	12	.
120		.C
	.A
V

2

3

4

120
V
. ±
A	12
.
C
.

1“L1” Terminal

2Neutral Terminal

3“L2” Terminal

Figure 15

5. Tighten all screws firmly.

IMPORTANT: Failure to tighten these screws firmly may result in wire failure at the terminal block.

6.Secure the strain relief to the power cord, or wires, where they enter the dryer cabinet.

7.Check the continuity of the ground connection before plugging the cord into an outlet. Use an acceptable indicating device connected to the center grounding pin of the plug and the green screw on the back of the cabinet.

8.Reinstall access cover and screw.

240 ± 12	0
V.A.C.
	V.A.C.

120				12
V		±			.
. ±				.C
A			120V
.
.	12		.A
C

DRY2016N

1Typical Four-Wire Receptacle

2Power Cord – Not Supplied with Dryer

3Strain Relief Nut

4Strain Relief

Figure 16

513005 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 19