Alliance Laundry Systems DRY710C manual Connecting Power Cord with Three-Wire Plug, Shut-Off Box

Installation

Connecting Power Cord with Three-Wire

Plug

NOTE: Four-wire cord is required for new branch- circuit installations, mobile homes or where codes do not permit grounding through neutral.

NOTE: THE POWER CORD IS NOT SUPPLIED WITH THE ELECTRIC

DRYER. TYPE OF POWER CORD AND GAUGE OF WIRE MUST

CONFORM TO LOCAL CODES AND INSTRUCTIONS.

		POWER SUPPLY	POWER SUPPLY
THE METHOD OF WIRING THE DRYER IS OPTIONAL AND SUBJECT
TO LOCAL CODE REQUIREMENTS.			1
NOTE: CONNECT THE DRYER TO THE POWER SUPPLY WITH THE
MAXIMUM RATED VOLTAGE LISTED ON THE NAMEPLATE.			2
			3
	A typical	INTERMEDIATE
	30-Amp		INTERMEDIATE
	Three-Wire	FUSE BOX (may
			SHUT-OFF BOX
	Receptacle	be omitted if
			(may or may not
	NEMA Type	service entrance
			be fused)
	10-30R	box is fused)
			4
		WALL
		RECEPTACLE	5
	120 ± 12
120 ± 12
	V.A.C.		6
V.A.C.
	240 ± 12		7
	V.A.C.

	NOTE: USE COPPER WIRE ONLY.	L1	L2		L1	L2
	SHORTER THAN 15 FT. (4.5 M) – USE 10 AWG	POWER CORD CONNECTION			DIRECT CONNECTION
	LONGER THAN 15 FT. (4.5 M) – USE 8 AWG						D816I
1	3 Wire Grounded Neutral 120/240 Volt, 60 Hertz		4	Metallic or Non-Metallic Sheathed Cable
	AC 1 Phase Service Entrance Switch Box			(Copper Wire Only)
	(Refer to NOTE above)		5	Power Cord (Not supplied with dryer)
2	30 Ampere Fuses or Circuit Breaker		6	Neutral
3	Neutral Wire		7	Terminal Block in Dryer

1.Disconnect power to dryer.

2.Remove access cover from rear of dryer.

Figure 12

3.Use a strain relief and insert end of power cord through power supply hole.

D695I

Figure 13

D696I

Figure 14

18 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 513005