Alliance Laundry Systems DRY710C manual Plug cord into separately fused

Page 25

The dryer is designed to be operated on a separate branch, polarized, three-wire, effectively grounded, 120 Volt, 60 Hertz, AC (alternating current) circuit protected by a 15 Ampere fuse, equivalent fusetron or circuit breaker.

The three-prong grounding plug on the power cord should be plugged directly into a polarized three-slot effectively grounded receptacle rated 120 Volts AC (alternating current) 15 Amps. Refer to Figure 32 to determine correct polarity of the wall receptacle.

Grounding Information

The dryer must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. The dryer is equipped with a cord having an equipment-grounding conductor and a 3 prong grounding plug. The three-prong grounding plug on the power cord should be plugged directly into a polarized three-slot effectively grounded receptacle rated 110/120 Volts AC (alternating current) 15 Amps.

WARNING

This dryer is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug.

W036

WARNING

Improper connection of the equipment- grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the dryer is properly grounded.

W038

Do not modify the plug provided with the dryer – if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

NOTE: Have a qualified electrician check the polarity of the wall receptacle. If a voltage reading is measured other than that illustrated, the qualified electrician should correct the problem.

Installation

Do not operate other appliances on the same circuit when this appliance is operating.

WARNING

To reduce the risk of an electric shock or fire, DO NOT use an extension cord or an adapter to connect the dryer to the electrical power source.

 

 

 

W037

1

2

3

 

 

 

120±12

0 V.A.C

 

V.A.C

 

 

 

D254I

 

 

120±12

 

 

 

V.A.C

 

 

 

 

 

4

 

 

 

5

Plug cord into separately fused

DRY2

 

15 Amp circuit.

 

 

 

 

DRY2022N

1

“L1”

 

 

2

Ground

 

 

3

Neutral

 

 

4

Neutral Side

 

 

5

Round Grounding Prong

 

Figure 32

513005

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

23

Image 25
Contents Clothes Dryer Page What to do if YOU Smell GAS Contents Explanation of Safety Messages Safety InformationImportant Safety Instructions Safety Information Dimensions InstallationMetered Models Tools Before You StartPosition and Level the Dryer Installing the DryerArea Description Free Standing/Alcove Closet Installation Connect Dryer Exhaust System Exhaust Direction ∙ Failure to exhaust dryer properly will void warrantyMaximum length of 4 in .2 cm diameter rigid metal duct Exhaust SystemMulti-Dryer Installation Exhaust Requirements Roof No Screen or Cap Wall Cm Minimum Gas Dryer Only Connect Gas Supply Pipe Installation Duct Station Minimum Diameter Collector DuctGrounding Information Electric Dryer Only Connect Electrical PlugWire Length Typical Receptacle SHUT-OFF BOX Connecting Power Cord with Three-Wire PlugConnecting Power Cord with Four-Wire Plug D695I Reverse Door, if Desired Reinstall nine screws removed in StepPlug In the Dryer Wipe Out Inside of DryerElectric Dryer Gas DryerPlug cord into separately fused Check Heat Source Recheck StepsElectric Dryers Gas DryersMeter Case VendingAdditional Dryer Security Operation Clean Lint FilterOperation Instructions Load LaundryTo Insert Card Set Fabric SelectorInsert Coins or Card To Insert MoneyStart Dryer Indicator LightsLubrication MaintenanceCare of Your Dryer Motor Overload Protector Lint FilterFor Energy Conservation Dryer Symptom Possible Cause/Solution Dryer won’t start TroubleshootingAlliance Laundry Systems Shepard Street Box Ripon, WI Contact InformationPage Fast Track for Installing the Dryer Installer Checklist