Alliance Laundry Systems DRY710C manual What to do if YOU Smell GAS

Page 3

WARNING

FOR YOUR SAFETY, the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death. Keep this manual for future reference. If this machine changes ownership, this manual must accompany machine.

W755

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Clear the room, building or area of all occupants.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

W052

IMPORTANT: Purchaser must consult the local gas supplier for suggested instructions to be followed if the dryer user smells gas. The gas utility instructions plus the SAFETY and WARNING note directly above must be posted in a prominent location near the dryer for customer use.

WARNING

Installation of unit must be performed by a qualified installer.

Install clothes dryer according to manufacturer’s instructions and local codes.

DO NOT install a clothes dryer with flexible plastic venting materials. If flexible metal (foil type) duct is installed, it must be of a specific type identified by the appliance manufacturer as suitable for use with clothes dryers. Refer to section on connecting exhaust system. Flexible venting materials are known to collapse, be easily crushed, and trap lint. These conditions will obstruct clothes dryer airflow and increase the risk of fire.

W729R1

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

W053

The following information applies to the state of Massachusetts, USA.

This appliance can only be installed by a Massachusetts licensed plumber or gas fitter.

This appliance must be installed with a 36 inch (91 cm) long flexible gas connector.

A “T-Handle” type gas shut-off valve must be installed in the gas supply line to this appliance.

This appliance must not be installed in a bedroom or bathroom.

513005

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

1

Image 3
Contents Clothes Dryer Page What to do if YOU Smell GAS Contents Safety Information Explanation of Safety MessagesImportant Safety Instructions Safety Information Installation DimensionsMetered Models Tools Before You StartPosition and Level the Dryer Installing the DryerArea Description Free Standing/Alcove Closet Installation Connect Dryer Exhaust System Exhaust Direction ∙ Failure to exhaust dryer properly will void warrantyMaximum length of 4 in .2 cm diameter rigid metal duct Exhaust SystemMulti-Dryer Installation Exhaust Requirements Roof No Screen or Cap Wall Cm Minimum Gas Dryer Only Connect Gas Supply Pipe Installation Duct Station Minimum Diameter Collector DuctGrounding Information Electric Dryer Only Connect Electrical PlugWire Length Typical Receptacle SHUT-OFF BOX Connecting Power Cord with Three-Wire PlugConnecting Power Cord with Four-Wire Plug D695I Reverse Door, if Desired Reinstall nine screws removed in StepGas Dryer Wipe Out Inside of DryerPlug In the Dryer Electric DryerPlug cord into separately fused Gas Dryers Recheck StepsCheck Heat Source Electric DryersVending Meter CaseAdditional Dryer Security Load Laundry Clean Lint FilterOperation Operation InstructionsTo Insert Money Set Fabric SelectorTo Insert Card Insert Coins or CardStart Dryer Indicator LightsMaintenance LubricationCare of Your Dryer Lint Filter Motor Overload ProtectorFor Energy Conservation Dryer Symptom Possible Cause/Solution Dryer won’t start TroubleshootingAlliance Laundry Systems Shepard Street Box Ripon, WI Contact InformationPage Fast Track for Installing the Dryer Installer Checklist