Alliance Laundry Systems DRY710C manual Before You Start, Tools

Page 8

Installation

Before You Start

Tools

For most installations, the basic tools you will need are:

 

1

2

 

 

3

 

5

4

 

 

D818I

1

Wrench

 

2

Screwdrivers

 

3

Level

 

4

Teflon Tape

 

5

Duct Tape

 

Figure 1

NOTE: An 8 in. (20.32 cm) coin drawer is required for coin operated models with standard capacity meter case and high capacity meter case models starting with Serial Nos. beginning 1010. High capacity meter case models with Serial Nos. beginning 0910 through 1010 require a 7.21 in. (18.31 cm) coin drawer.

Card Reader Models

The machine is shipped from the factory with the Electronic Control Diagnostic Harness Assembly unplugged. To avoid unauthorized manual programming or vending perform the following steps.

1.Open service door. Refer to Figure 1.

2.Locate diagnostic harness on electronic control.

3.Plug connectors for “white/black” wire and “red/ blue” wire together.

.

 

 

1

1

FLW6R

Service Door

Figure 2

WARNING

Any disassembly requiring the use of tools must be performed by a suitably qualified service person.

W299

6

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

513005

Image 8
Contents Clothes Dryer Page What to do if YOU Smell GAS Contents Important Safety Instructions Safety InformationExplanation of Safety Messages Safety Information Metered Models InstallationDimensions Before You Start ToolsInstalling the Dryer Position and Level the DryerArea Description Free Standing/Alcove Closet Installation Connect Dryer Exhaust System ∙ Failure to exhaust dryer properly will void warranty Exhaust DirectionExhaust System Maximum length of 4 in .2 cm diameter rigid metal ductMulti-Dryer Installation Exhaust Requirements Roof No Screen or Cap Wall Cm Minimum Installation Duct Station Minimum Diameter Collector Duct Gas Dryer Only Connect Gas Supply PipeElectric Dryer Only Connect Electrical Plug Grounding InformationWire Length Typical Receptacle Connecting Power Cord with Three-Wire Plug SHUT-OFF BOXConnecting Power Cord with Four-Wire Plug D695I Reinstall nine screws removed in Step Reverse Door, if DesiredWipe Out Inside of Dryer Plug In the DryerElectric Dryer Gas DryerPlug cord into separately fused Recheck Steps Check Heat SourceElectric Dryers Gas DryersAdditional Dryer Security VendingMeter Case Clean Lint Filter OperationOperation Instructions Load LaundrySet Fabric Selector To Insert CardInsert Coins or Card To Insert MoneyIndicator Lights Start DryerCare of Your Dryer MaintenanceLubrication For Energy Conservation Lint FilterMotor Overload Protector Troubleshooting Dryer Symptom Possible Cause/Solution Dryer won’t startContact Information Alliance Laundry Systems Shepard Street Box Ripon, WIPage Installer Checklist Fast Track for Installing the Dryer