ADC AD-115ES installation manual American Dryer Corp 113202

Page 14

2.The V-belts are disconnected from the basket drive motor for shipping. Reconnect V-belts, using the following instructions, before starting the dryer.

a.Remove hardware holding back (belt) guard and remove guard from dryer.

b.Lay one (1) belt into motor sheave (pulley) groove and wind belt into corresponding groove of the idler pulley by rotating the idler pulley by hand. Rotate the idler pulley an extra turn or two (2) to ensure that the belt is tracking properly in the motor sheave (pulley) and idler pulley grooves without twisting.

c.Repeat procedure to reconnect the remaining belt.

d.Replace back (belt) guard and hardware.

3.If more headroom is needed when moving dryer into position, the top console (module) may be removed, using the following instructions.

a.Disconnect the ground wire (A) at the rear upper left hand corner of dryer.

b.Remove the eight (8) sets of nuts and washers (B) holding the console (module) to base.

c.Open the control door and control panel, and disconnect the white 15-pin plug connector (C) located in the base of the control box.

d.Disconnect white plug connector located outside backside of the control box (provides power to heat circuit).

e.Lift the console (module) off of the dryer base.

IMPORTANT: The dryer must be transported and handled in an upright position at ALL times.

10

American Dryer Corp.

113202 - 10

Page 13 Page 15
Image 14
Page 13 Page 15
Contents AD-115ES Installation Manual Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Safety Precautions SectionStandard SPECIFICATIONS/COMPONENT Identification SpecificationsSpecifications Gas, Electric, and Steam Component Identification 113202 Installation Procedures Location RequirementsUnpacking and Setting UP American Dryer Corp 113202 This Exhaust Duct Transition Piece Must be Installed First Dryer Enclosure Requirements Fresh AIR Supply RequirementsExhaust Requirements General Exhaust Ductwork InformationAmerican Dryer Corp 113202 Outside Ductwork Protection American Dryer Corp 113202 Electrical Information Reversing, 3ø Motor Gas and Steam Reversing, 3ø Motor Electric American Dryer Corp 113202 GAS Information Type of GAS Type of GAS American Dryer Corp 113202 Operating Steam Pressure Steam InformationSteam Damper System Compressed Air Supply Air Pressure113202 Water Information Before YOU Start Check Local Codes and Permits113202 Typical Water Supply Preparation for Operation and START-UP Preoperational Test Basket Tumbler Coating Dual Timer Dryers Preoperational InstructionsReversing Timer SPIN/DWELL Adjustments Shutdown InstructionsParts SERVICE/PARTS InformationService Warranty Warranty InformationReturning Warranty Cards Returning Warranty PartsAmerican Dryer Corp 113202 Suggested Cleaning Schedule Routine MaintenanceCleaning Adjustments LubricationData Label Information Procedure for Functional Check Replacement Components 113202 Dual Timer Manual Reset Burner HI-LIMIT InstructionsPhase 113202 ADC Part No 10 12/10/08
Top Page Image Contents