Amana Automatic Dryer Cabinet Dimensions, Tools needed for installation, Items Provided

Tools needed for installation

•Teflon tape or pipe

joint compound (gas only)

•Cutting knife

•Pipe wrench (gas only)

•Nut drivers

•Level

•Screw driver (standard)

•Duct tape

•Crescent wrench

ITEMS PROVIDED

Electric Dryer	Gas Dryer
Only	Only

Proper installation is the responsibility of the owner.

HOWEVER, SERVICE CALLS PERFORMED AS A RESULT OF POOR SET-UP, ADJUSTMENT AND CONNECTION ARE THE RESPONSIBILITY OF THE INSTALLER.

Make sure you have everything necessary for proper installation.

1.GROUNDED ELECTRICAL OUTLET is required. See Electric Requirements.

2.POWER CORD for electric dryers (except Canada).

3.GAS LINES (if a gas dryer) must meet National and Local Codes.

4.EXHAUST SYSTEM – must be rigid metal or flexible stiff walled metal exhaust ducting. See Exhaust Requirements.

CABINET DIMENSIONS

7200 series	INCH (CM)
A. Height-overall	38” (96.5)
B. Width	27” (68.6)
C. Depth-With Dryer Door Open 90°	46-7/16” (123.0)
D. Depth	28” (71.0)
E. Bottom Vent Hole Location - From Back	7-1/2” (19)
To Center of Hole
Side Vent Hole - From Back To Center Of	8-1/2” (21.6)
Hole

Note:

The height of the dryer from top to floor is 38" with the leveling leg screwed all the way in. The customer can unscrew the leg out an additional 7\8" for a total overall height of 38 7/8".

2