American Dryer Corp AD-115ES II installation manual

Page 16

2.The V-belts are disconnected from the basket drive motor for shipping. Reconnect V-belts before starting the dryer.

a.To reconnect V-belts

1)Remove hardware holding back (belt) guard and remove guard from dryer.

2)Lay one (1) belt into motor sheave (pulley) groove and wind belt into corresponding groove of the idler pulley by rotating the idler pulley by hand. Rotate the idler pulley an extra turn or two (2) to insure that the belt is tracking properly in the motor sheave (pulley) and idler pulley grooves without twisting.

3)Repeat procedure to reconnect the remaining belt.

4)Replace back (belt) guard and hardware.

3.If more headroom is needed when moving dryer into position, the top console (module) may be removed.

a.To remove top console (module)

1)Disconnect the ground wire (A) at the rear upper left hand corner of dryer.

2)Remove the eight (8) sets of nuts and washers (B) holding the console (module) to base.

3)Open the control door and control panel, and disconnect the white 15-pin plug connector (C) located in the base of the control box.

4)Disconnect white plug connector located outside backside of the control box (provides power to heat circuit).

5)Lift the console (module) off of the dryer base.

IMPORTANT: The dryer must be transported and handled in an upright position at ALL times.

12

Image 16

Contents AD-115ES Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Data Label Cleaning Adjustments LubricationGas Models Only Electric or Steam Models Only Important Information Receiving and HandlingSafety Precautions What to do if YOU Smell GASStandard SPECIFICATIONS/COMPONENT Identification SpecificationsPage Component Identification Page Installation Procedures Location RequirementsUnpacking and Setting UP Page This Exhaust Duct Transition Piece Must be Installed First Dryer Enclosure Requirements Fresh AIR Supply Requirements Exhaust Requirements General Exhaust Ductwork InformationPage Page Page Page Page Page Page Electrical Information Electrical Service Specifications PER Dryer ADE-115ES 60 Kw Electric Oven Reversing, 3ø Motor ADE-115ES 72 Kw Electric Oven Reversing, 3ø Motor Page Page GAS Information 26.1 mb 27.4 mbPage Page 689 kPa Steam Information170.1 kg/hr Page Compressed AIR AIR Pressure Supply Page Preparation for Operation and START-UP Preoperational Tests Page Shutdown Instructions Basket Tumbler CoatingService SERVICE/PARTS InformationParts Warranty Information Returning Warranty CardsWarranty Returning Warranty PartsPage Routine Maintenance CleaningSuggested Cleaning Schedule Clean the lint drawer or screen every third or fourth loadSteam Dryers Adjustments LubricationNo light emitting diode L.E.D. display TroubleshootingDrive motor is not operating does not start Blower motor is not operating does not start Microprocessor controller computer display reads dSFL Microprocessor controller computer display reads doorFailed microprocessor controller computer No heat for Steam Models only No heat for Electric Models onlyDryer operates but is taking too long to dry Condensation on main door glassDryer is making scraping noise at basket tumbler area Excessive noise or vibrationData Label Information Data LabelSerial Number Reversing Timer SPIN/DWELLADJUSTMENTS Timing LegendProcedure for Functional Check Replacement Components Page Page P O R T a N T ADC P/N114501