American Dryer Corp AD-115ES II Microprocessor controller computer display reads dSFL

Page 54

H.Both drive motor and blower motor run a few minutes and then stop...microprocessor controller (computer) display continues to read time or percent of extraction and ALL indicator dots are off...

1.Fault in main door switch circuit...

a.Failed main door switch.

b.Main door switch is out of adjustment.

c.Loose connection in door switch circuit.

2.Fault in lint drawer switch circuit...

a.Lint drawer switch is out of proper adjustment.

b.Loose connection in the lint drawer switch circuit.

I.Microprocessor controller (computer) display reads “dSFL”...

1.Fault in microprocessor heat sensing circuit...

a.Blown 1/8-Amp (“dSFL”) fuse on microprocessor controller (computer).

b.Failed microprocessor temperature sensor.

c.Failed microprocessor controller (computer).

d.Broken wire or connection somewhere between the microprocessor controller (computer) and the microprocessor temperature sensor.

J.Microprocessor controller (computer) display reads “door”...

1.Fault (open circuit) in main door or lint drawer switch circuit...

a.Lint drawer is not closed ALL the way.

b.Lint drawer switch is out of proper adjustment.

c.Failed lint drawer switch.

d.Failed main door switch.

e.Broken connection or wire in main door or lint drawer circuit.

f.Failed 24 VAC transformer.

K.Microprocessor controller (computer) will not accept any keyboard (touch pad) entries, i.e., light emitting diode (L.E.D.) display reads “FILL” and when keyboard (touch pad) entries are selected, the L.E.D. display continues to read “FILL”...

1.Failed keyboard (touch pad) label assembly.

50

Image 54

Contents AD-115ES Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Cleaning Adjustments Lubrication Data LabelGas Models Only Electric or Steam Models Only Important Information Receiving and HandlingSafety Precautions What to do if YOU Smell GASStandard SPECIFICATIONS/COMPONENT Identification SpecificationsPage Component Identification Page Installation Procedures Location RequirementsUnpacking and Setting UP Page This Exhaust Duct Transition Piece Must be Installed First Dryer Enclosure Requirements Fresh AIR Supply Requirements Exhaust Requirements General Exhaust Ductwork InformationPage Page Page Page Page Page Page Electrical Information Electrical Service Specifications PER Dryer ADE-115ES 60 Kw Electric Oven Reversing, 3ø Motor ADE-115ES 72 Kw Electric Oven Reversing, 3ø Motor Page Page GAS Information 26.1 mb 27.4 mbPage Page Steam Information 689 kPa170.1 kg/hr Page Compressed AIR AIR Pressure Supply Page Preparation for Operation and START-UP Preoperational Tests Page Shutdown Instructions Basket Tumbler CoatingSERVICE/PARTS Information ServiceParts Warranty Warranty InformationReturning Warranty Cards Returning Warranty PartsPage Suggested Cleaning Schedule Routine MaintenanceCleaning Clean the lint drawer or screen every third or fourth loadSteam Dryers Adjustments LubricationTroubleshooting No light emitting diode L.E.D. displayDrive motor is not operating does not start Blower motor is not operating does not start Microprocessor controller computer display reads dSFL Microprocessor controller computer display reads doorFailed microprocessor controller computer No heat for Steam Models only No heat for Electric Models onlyDryer operates but is taking too long to dry Condensation on main door glassDryer is making scraping noise at basket tumbler area Excessive noise or vibrationData Label Information Data LabelSerial Number Reversing Timer SPIN/DWELLADJUSTMENTS Timing LegendProcedure for Functional Check Replacement Components Page Page P O R T a N T ADC P/N114501