Location Requirements, You will need | Maytag W10057352A instruction

Maytag W10057352A Location Requirements, You will need, Installation clearances, Dryer Dimensions

Location Requirements

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

You will need

A location that allows for proper exhaust installation. A gas dryer must be exhausted to the outdoors. See “Venting Requirements.”

A separate 30-amp circuit.

If you are using a power supply cord, a grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See “Electrical Requirements.”

Cold water faucets located within 4 ft (1.2 m) of the dryer, and water pressure of 20-100 psi (137.9-689.6 kPa). You may use the cold water supply from your washer using the “Y” connector provided.

A sturdy floor to support the total dryer weight of 200 lbs (90.7 kg). The combined weight of a companion appliance should also be considered.

A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. If slope is greater than 1" (2.5 cm), install Extended Dryer Feet Kit, Part Number 279810. Clothes may not tumble properly and automatic sensor cycles may not operate correctly if dryer is not level.

For a garage installation, you will need to place the dryer at least 18" (46 cm) above the floor. If using a pedestal, you will need 18" (46 cm) to the bottom of the dryer.

Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. This can result in longer drying times.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes or sleeping quarters. Contact your local building inspector.

NOTE: No other fuel-burning appliance can be installed in the same closet as a dryer.

Installation clearances

The location must be large enough to allow the dryer door to open fully.

Dryer Dimensions

51½" (130.81 cm)

38"

(96.52 cm)

*31½"

(80 cm)27"

(68.6 cm)

*Most installations require a minimum 5" (12.7 cm) clearance behind the dryer for the exhaust vent with elbow. See “Venting Requirements.”

Installation spacing for recessed area or closet installation

The following spacing dimensions are recommended for this dryer. This dryer has been tested for spacing of 0" (0 cm) clearance on the sides and rear. Recommended spacing should be considered for the following reasons:

Additional spacing should be considered for ease of installation and servicing.

Additional clearances might be required for wall, door and floor moldings.

Additional spacing should be considered on all sides of the dryer to reduce noise transfer.

For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.

Companion appliance spacing should also be considered.

Custom undercounter installation - Dryer only

(0 cm)

38" min. (96.52 cm)

1"*		27"		1"*
(2.5 cm)	(68.6 cm)		(2.5 cm)
(2.5 cm)	(68.6 cm)		(2.5 cm)

*Required spacing

W10057352A specifications

The Maytag W10057352A is a highly regarded appliance designed to enhance the efficiency and functionality of modern kitchens. This product is primarily recognized as a durable and reliable power source for numerous kitchen tasks, embodying the brand’s commitment to quality and performance.

One of the standout features of the Maytag W10057352A is its robust construction. Built with heavy-duty materials, it is engineered to withstand the rigors of daily use, ensuring longevity and continued performance over time. This appliance is designed for those who value reliability in their kitchen equipment.

The W10057352A incorporates advanced technology that sets it apart in the market. It features a powerful motor that delivers exceptional performance, making it ideal for a variety of tasks from mixing to mashing. The device is equipped with variable speed settings, allowing users to easily adjust the speed based on their specific cooking needs. This level of control enhances user experience, ensuring that they can achieve the desired consistency and texture in their culinary creations.

In terms of ease of use, the Maytag W10057352A is designed with user-friendly controls that simplify operation. Its ergonomic handle ensures a comfortable grip, and the intuitive buttons provide quick access to the various functions. Moreover, the appliance is easy to clean, with many components designed for convenient disassembly and dishwasher-safe features. This aspect is particularly appealing to busy individuals who seek low-maintenance solutions in their kitchen.

Another key characteristic of the W10057352A is its versatility. It is compatible with a range of attachments and accessories, allowing users to customize the appliance according to their cooking requirements. Whether users are whipping, kneading, or blending, the Maytag W10057352A offers flexibility to tackle a myriad of recipes.

Energy efficiency is also an integral part of the design philosophy behind the Maytag W10057352A. The appliance operates efficiently, minimizing energy consumption without compromising performance. This focus on energy efficiency not only benefits users’ utility bills but also aligns with environmentally conscious practices.

Overall, the Maytag W10057352A stands out as a powerful, efficient, and versatile appliance that embodies the brand's dedication to quality. Its robust construction, advanced technology, user-friendly features, and adaptability make it a valuable addition to any kitchen. Whether for a budding home cook or a seasoned chef, the Maytag W10057352A is poised to meet and exceed culinary expectations.