Humminbird HDR 650 manual Installing the Buzzer, Connecting to the Power Supply

Page 11

5. Installing the Buzzer

Securing the Buzzer

Buzzer

Secure the buzzer to a nearby wire bundle using the cable ties (included).

6. Connecting to the Power Supply

Use the followinginformation to connect your HDR 650 to an appropriatepower supply:

•If your boat has an electrical system, there is probably a fuse panel in the console area that can be used to attach the HDR 650 power cable.

•If a fuse terminal is available, use crimp-on type electrical connectors (not included) that match the terminal on the fuse panel. Attach the black wire to ground and the red wire to 12 VDC power. Youmust use a 1-Amp fuse in the connection.

•36" of power cable is included;you may shortenor lengthenthis cable using 18-gauge, multi-strand copper wire.

7	Installation

Image 11

Contents HDR 650 Installation Operations Manual Thank You Table of Contents Maintenance How Sonar Works Installation Overview Installing the HDR Cutting the Mounting Hole Locating the HDR 650 Mounting PositionHDR Face Plate Trim Ring Tabs Customizing and Assembling the HDRHDR 650 Control Head Installing the HDRCollar Gasket DashboardView Buzzer Installing the BuzzerConnecting to the Power Supply Inline Fuse Holder Installing the TransducerTransducer Installation Overview StepRib Transom Transducer InstallationLocating the Transducer Mounting Position Rivets Strakes TransomHullDeadrise Angle LevelPreparing the Mounting Location Drill Holes Assembling the Transducer and Initial Mounting4th hole Mark Initial Bead Alignment Number Transom Angle Measured Distance Transom Angle in degrees MeasuredWeight DistanceBead Ratchet Knuckle Beads RatchetRib Snap the pivot arm down into place Trailingedge One click too low Leading edge One click too highRouting the Cable Transom Mount Transducer Installation See the illustration Storing Excess Cable Connecting the CableTest and Finish the Installation Storing Excess Cable Gathered at one location as shownLevel Seam aligned with boat hull Rib Ratchet BeadTransom Mount Transducer Installation Locking Down the Transducer Optional Inside the Hull Transducer Installation Positioning the Transducer and Preferred Mounting Area Trial InstallationRouting the Cable Make sure the position of the transducer is marked Permanently Mounting the TransducerTrolling Motor Transducer Options Trolling Motor Transducer InstallationDepth Units Shallow Alarm Icon IndicatesOperating the HDR HDR 650 Control HeadKey Functions Overview Power On/OffSet Units UnitsSet Shallow Alarm Icon Shallow AlarmSet Deep Alarm Icon Deep AlarmPostiveOffset NumberIcon NegativeOffset NumberIconTransducer Maintenance MaintenanceHDR 650 Maintenance HDR 650 Doesnt Power Up TroubleshootingBottom Reading Disappears During a Hard Turn No Bottom Reading on the DisplayNo Continuous Depth Display in Very Shallow Water Screen Fades, Images are not SharpYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Specifications Contact Humminbird