Humminbird HDR 650 manual Customizing and Assembling the HDR, HDR Face Plate Trim Ring Tabs

Page 9

3. Customizing and Assembling the HDR 650

Your HDR 650 includes a variety of face plates and trim rings so that you can customize the appearance.

1.Select one face plate and one trim ring.

2.Peel off the protective backing from the face plate. Be careful not to let the adhesive touch anything prematurely.

CAUTION: In order to provide a lasting, waterproof bond, the face plate adhesive is extremely sticky, and you will NOT be able to re-position it once you have stuck it onto the face of the HDR 650.

3.Carefully line up the face plate with the face of the HDR 650. Press the face plate into place so that all keys are accessible and the displayis visible(see illustration).

4.Align the inside tabs of the trim ring with the HDR 650 tabs, and snap the trim ring onto the front of the HDR 650 (see illustration).

HDR 650

Face Plate

Trim Ring

Tabs

5	Installation

Image 9

Contents HDR 650 Installation Operations Manual Thank You Table of Contents Maintenance How Sonar Works Installation Overview Installing the HDR Cutting the Mounting Hole Locating the HDR 650 Mounting PositionHDR Face Plate Trim Ring Tabs Customizing and Assembling the HDRInstalling the HDR Collar Gasket DashboardViewHDR 650 Control Head Installing the Buzzer Connecting to the Power SupplyBuzzer Inline Fuse Holder Installing the TransducerTransducer Installation Overview Locating the Transducer Mounting Position Transom Transducer InstallationRivets Strakes TransomHull StepRibDeadrise Angle LevelPreparing the Mounting Location Assembling the Transducer and Initial Mounting 4th hole Mark InitialDrill Holes Bead Alignment Number Transom Angle Measured Distance Transom Angle in degrees MeasuredWeight DistanceKnuckle Beads Ratchet RibBead Ratchet Snap the pivot arm down into place Trailingedge One click too low Leading edge One click too highRouting the Cable Transom Mount Transducer Installation Test and Finish the Installation Connecting the CableStoring Excess Cable Gathered at one location as shown See the illustration Storing Excess CableLevel Seam aligned with boat hull Rib Ratchet BeadTransom Mount Transducer Installation Locking Down the Transducer Optional Inside the Hull Transducer Installation Positioning the Transducer and Preferred Mounting Area Trial InstallationRouting the Cable Make sure the position of the transducer is marked Permanently Mounting the TransducerTrolling Motor Transducer Options Trolling Motor Transducer InstallationOperating the HDR Units Shallow Alarm Icon IndicatesHDR 650 Control Head DepthKey Functions Overview Power On/OffSet Units UnitsSet Shallow Alarm Icon Shallow AlarmSet Deep Alarm Icon Deep AlarmPostiveOffset NumberIcon NegativeOffset NumberIconMaintenance HDR 650 MaintenanceTransducer Maintenance HDR 650 Doesnt Power Up TroubleshootingNo Continuous Depth Display in Very Shallow Water No Bottom Reading on the DisplayScreen Fades, Images are not Sharp Bottom Reading Disappears During a Hard TurnYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Specifications Contact Humminbird