Humminbird HDR 650 manual Returning Your Unit for Service

Page 45

Returning Your Unit for Service

Before sending your unit in for repair, please contact the factory, either by phone or by email, to obtain a Repair Authorization Number for your unit.

NOTE: Please do not return your Humminbird® to the store for service.

Please have your product model name and serial number availablebefore calling the factory. If you contact the factory by e-mail, please include your product model name and serial number in the e-mail, and use Request for Repair Authorization Number for your e-mail subject header. You should include your Repair Authorization Number in all subsequent communicationsabout your unit.

For IN-WARRANTY service, complete the followingsteps:

Obtain a Repair Authorization Number from the Humminbird® Customer Resource Center.

Tag product with your name, street address, phone number and your assigned Repair Authorization Number.

Include a brief written description of the problem.

Include a copy of your receipt (to show proof and date of purchase).

Return product freight prepaid to Humminbird®, using an insured carrier with delivery confirmation.

For OUT-OF-WARRANTY service, complete the following steps:

Obtain a Repair Authorization Number from the Humminbird® Customer Resource Center.

Include payment in the form of credit card number and expiration date, money order or personal check. Please do not send cash.

Tag product with your name, street address, phone number and your assigned Repair Authorization Number.

Include a brief written description of the problem.

Return product freight prepaid to Humminbird®, using an insured carrier with delivery confirmation.

41

Warranty and Service Policy

Image 45
Contents HDR 650 Installation Operations Manual Thank You Table of Contents Maintenance How Sonar Works Installation Overview Installing the HDR Cutting the Mounting Hole Locating the HDR 650 Mounting PositionHDR Face Plate Trim Ring Tabs Customizing and Assembling the HDRInstalling the HDR Collar Gasket DashboardViewHDR 650 Control Head Installing the Buzzer Connecting to the Power SupplyBuzzer Inline Fuse Holder Installing the TransducerTransducer Installation Overview Locating the Transducer Mounting Position Transom Transducer InstallationRivets Strakes TransomHull StepRibDeadrise Angle LevelPreparing the Mounting Location Assembling the Transducer and Initial Mounting 4th hole Mark InitialDrill Holes Bead Alignment Number Transom Angle Measured Distance Transom Angle in degrees MeasuredWeight DistanceKnuckle Beads Ratchet RibBead Ratchet Snap the pivot arm down into place Trailingedge One click too low Leading edge One click too highRouting the Cable Transom Mount Transducer Installation Test and Finish the Installation Connecting the CableStoring Excess Cable Gathered at one location as shown See the illustration Storing Excess CableLevel Seam aligned with boat hull Rib Ratchet BeadTransom Mount Transducer Installation Locking Down the Transducer Optional Inside the Hull Transducer Installation Positioning the Transducer and Preferred Mounting Area Trial InstallationRouting the Cable Make sure the position of the transducer is marked Permanently Mounting the TransducerTrolling Motor Transducer Options Trolling Motor Transducer InstallationOperating the HDR Units Shallow Alarm Icon IndicatesHDR 650 Control Head DepthKey Functions Overview Power On/OffSet Units UnitsSet Shallow Alarm Icon Shallow AlarmSet Deep Alarm Icon Deep AlarmPostiveOffset NumberIcon NegativeOffset NumberIconMaintenance HDR 650 MaintenanceTransducer Maintenance HDR 650 Doesnt Power Up TroubleshootingNo Continuous Depth Display in Very Shallow Water No Bottom Reading on the DisplayScreen Fades, Images are not Sharp Bottom Reading Disappears During a Hard TurnYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Specifications Contact Humminbird