Humminbird HDR 650 manual Set Deep Alarm Icon

Page 38

Deep Alarm

The Deep Alarm will sound when the measured depth is greaterthan the setting.

1.Press the MENU key until the Deep Alarm icon is displayed and flashingon the screen.

Set

Deep Alarm Icon

2.Press the UP or DOWN arrow key to change the setting. (Off, 20 - 99 feet, 6 - 30 meters, or 3.3 - 16 fathoms; Default = Off)

NOTE: The minimum Deep Alarm setting cannot meet or drop below the current Shallow Alarm setting (see the Shallow Alarm section).

3.After your selection is made, wait 5 seconds for the unit to returnto normal operation. Your settings are saved automatically, and the Deep icon will be visible on the display.

4.Alarm: If the depth of the water is greater than the saved setting, the alarm will sound and the alarm icon will flash on the screen.

Mute: Press any key to mute the alarm.

Adjust: Press the MENU key and follow the instructions in step 2 to adjust the alarm setting.

Operations

34

Image 38

Contents HDR 650 Installation Operations Manual Thank You Table of Contents Maintenance How Sonar Works Installation Overview Installing the HDR Locating the HDR 650 Mounting Position Cutting the Mounting HoleCustomizing and Assembling the HDR HDR Face Plate Trim Ring TabsHDR 650 Control Head Installing the HDRCollar Gasket DashboardView Buzzer Installing the BuzzerConnecting to the Power Supply Installing the Transducer Inline Fuse HolderTransducer Installation Overview Rivets Strakes TransomHull Transom Transducer InstallationLocating the Transducer Mounting Position StepRibLevel Deadrise AnglePreparing the Mounting Location Drill Holes Assembling the Transducer and Initial Mounting4th hole Mark Initial Transom Angle in degrees MeasuredWeight Distance Bead Alignment Number Transom Angle Measured DistanceBead Ratchet Knuckle Beads RatchetRib Snap the pivot arm down into place One click too high Trailingedge One click too low Leading edgeRouting the Cable Transom Mount Transducer Installation Storing Excess Cable Gathered at one location as shown Connecting the CableTest and Finish the Installation See the illustration Storing Excess CableLevel Seam aligned with boat hull Bead Rib RatchetTransom Mount Transducer Installation Locking Down the Transducer Optional Inside the Hull Transducer Installation Trial Installation Positioning the Transducer and Preferred Mounting AreaRouting the Cable Permanently Mounting the Transducer Make sure the position of the transducer is markedTrolling Motor Transducer Installation Trolling Motor Transducer OptionsHDR 650 Control Head Units Shallow Alarm Icon IndicatesOperating the HDR DepthPower On/Off Key Functions OverviewUnits Set UnitsShallow Alarm Set Shallow Alarm IconDeep Alarm Set Deep Alarm IconNegativeOffset NumberIcon PostiveOffset NumberIconTransducer Maintenance MaintenanceHDR 650 Maintenance Troubleshooting HDR 650 Doesnt Power UpScreen Fades, Images are not Sharp No Bottom Reading on the DisplayNo Continuous Depth Display in Very Shallow Water Bottom Reading Disappears During a Hard TurnYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Specifications Contact Humminbird