Humminbird Operating the HDR, HDR 650 Control Head, Depth, Units Shallow Alarm Icon Indicates

Page 34

Operating the HDR 650

YourHDR 650 Digital Depth Sounder sends a sound wave signal and determines distance by measuring the time betweenthe transmission of the sound wave and when the sound wave is reflected off of an object. As your HDR 650 transducer receives sonar signals, it converts them to a digital depth that is shown on the HDR 650 display.The depth reading is continuously updated as you travel across the water. The liquid crystal display (LCD) offers sharp viewing, even in bright, direct sunlight, and is continuouslylit for nighttime operation.

NOTE: Actual depth capability depends on such factors as bottom hardness, water conditions, and transducer installation. Units will typically read to deeper depths in fresh water than in salt water.

The HDR 650 Control Head

The HDR 650 uses a backlit display,together with a 3-button keypad, to control all user functions. The illustration below shows an example of the digital display.

HDR 650

Depth

Alarm Icon (flashes to indicate alert)

Units

Shallow Alarm Icon

(indicates

Shallow Alarm is set)

DOWN arrow key

MENU key

UP arrow key

Operations

30

Image 34
Contents HDR 650 Installation Operations Manual Thank You Table of Contents Maintenance How Sonar Works Installation Overview Installing the HDR Locating the HDR 650 Mounting Position Cutting the Mounting HoleCustomizing and Assembling the HDR HDR Face Plate Trim Ring TabsCollar Gasket DashboardView Installing the HDRHDR 650 Control Head Connecting to the Power Supply Installing the BuzzerBuzzer Installing the Transducer Inline Fuse HolderTransducer Installation Overview Rivets Strakes TransomHull Transom Transducer InstallationLocating the Transducer Mounting Position StepRibLevel Deadrise AnglePreparing the Mounting Location 4th hole Mark Initial Assembling the Transducer and Initial MountingDrill Holes Transom Angle in degrees MeasuredWeight Distance Bead Alignment Number Transom Angle Measured DistanceRib Knuckle Beads RatchetBead Ratchet Snap the pivot arm down into place One click too high Trailingedge One click too low Leading edgeRouting the Cable Transom Mount Transducer Installation Storing Excess Cable Gathered at one location as shown Connecting the CableTest and Finish the Installation See the illustration Storing Excess CableLevel Seam aligned with boat hull Bead Rib RatchetTransom Mount Transducer Installation Locking Down the Transducer Optional Inside the Hull Transducer Installation Trial Installation Positioning the Transducer and Preferred Mounting AreaRouting the Cable Permanently Mounting the Transducer Make sure the position of the transducer is markedTrolling Motor Transducer Installation Trolling Motor Transducer OptionsHDR 650 Control Head Units Shallow Alarm Icon IndicatesOperating the HDR DepthPower On/Off Key Functions OverviewUnits Set UnitsShallow Alarm Set Shallow Alarm IconDeep Alarm Set Deep Alarm IconNegativeOffset NumberIcon PostiveOffset NumberIconHDR 650 Maintenance MaintenanceTransducer Maintenance Troubleshooting HDR 650 Doesnt Power UpScreen Fades, Images are not Sharp No Bottom Reading on the DisplayNo Continuous Depth Display in Very Shallow Water Bottom Reading Disappears During a Hard TurnYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Specifications Contact Humminbird